3510 sec code problem

[bone]

HI!

Maybe someone run into the same problem and id like
to ask for the share of the solution of this stupid problem:

3510 -> master code calculated with dongleV2 OK
unlocked without any problem
then

asks for security code

problem is that it was factory 12345 originally
when phone asked ... entered correctly ... not accepted....

then i tried maestro, dct4tweek
using sec code reset function.

all those wrote ALL OK SEC CODE RESETED TO FACTORY 12345
..but...

same thing after that ... phone still asks for sec code and not accepting 12345.

no idea,

maybe setting to full factory would solve, but what sw to use?
(i thought maybe entering again that #pw would reset phone again and maybe doing the job but after entering code again it
says phone doesnt have restrictions and doin nothing)


a fast response, help would be very appreciated!!
any solution advice is warmly welcome !

thanks in advance,

bone

[sagarka]

hi all software link this cant be reset all the dct4 fone
u should always use fbus that wil work on all the dct4 fone and also new fone
enjoy it
if n e problem u can asked agian

[bone]

hi sagarka,

10x for response,
cable is auto f-mbus cheap chinese,
i guess it should work,
worked with first dct4 direct unlockers fine..
(dct4 goes test n local mode fine with cable)

btw does any logomanager or oxygen or something like these
work on 3510 like on old dct3s to read out sec code?
(just to check)

and furthermore, is there any dct4 sw to check mccmnc, lock state
sw reset function etc? (i was out from mobile scene for a while )

but main point is still that sec code on that stupid 3510, so please
respond if u have idea

10x!
bone

[sagarka]

yeap
just use b-phreaks it can read the mccmnc both of software can use all kind of cable its not problem that cable is fbus or mbus
all the cable can use on these software
if u have not b-phreaks mail me at [email protected]
i will send u the soft
enjoy it