6310 start up problem after change pa - GSM-Forum

gsm_style · 11-08-2004, 19:57

i change pa off 6310 and after that phone will not go on, try to flash with ufs3 and give error bad response from upp, what did i wrong and how to repair it?

mohammed · 11-09-2004, 03:04

hi man

1---> REMOVE pa from phone N CHECK weather it switch on OR not
a-> this is rare ,Seems Perhaps "maybe"u melted power button,BUT if this was case PHONE should flash
so what i deduce is that

U CHANGE pa n PHONE went dead after that, IN this case and with THAT ERROR on ufs

this sequence try
1:change UEM
2:change upp

reason SIMPLE

"to much heat apply to BOARD MAYBE"

goodluck

gsm_style · 11-09-2004, 20:00

thank you man, problem are the pa, change it to an other one and now its ok, thank you for your help

mohammed · 11-09-2004, 21:08

hi man

glad to help

11-08-2004, 19:57	#1 (permalink)
gsm_style Freak Poster Join Date: Mar 2003 Location: nederland Age: 52 Posts: 251 Member: 24929 Status: Offline Thanks Meter: 7	6310 start up problem after change pa i change pa off 6310 and after that phone will not go on, try to flash with ufs3 and give error bad response from upp, what did i wrong and how to repair it?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
n73 phone start up failed after after write rpl	unlock & flash	Nokia Base Band 5 ( BB-5 )	3	09-16-2008 21:58
Big problem After Changing PA	Black-Axe	Nokia Hardware & Hardware Repair	11	11-22-2002 06:34
T28 problem after change PA.	chris_ua	Sony Ericsson Hardware Repair	2	10-05-2002 07:37
T28s random signal after changing PA	chrisro	Old Ericsson Phones & Sony Phones	3	11-15-2001 19:51
T28 No access after change PA	fm-gsm	Sony Ericsson Hardware Repair	4	11-03-2001 18:32

11-09-2004, 03:04	#2 (permalink)
mohammed No Life Poster Join Date: Sep 2002 Location: max232 chip Posts: 690 Member: 16036 Status: Offline Thanks Meter: 5	hi man 1---> REMOVE pa from phone N CHECK weather it switch on OR not a-> this is rare ,Seems Perhaps "maybe"u melted power button,BUT if this was case PHONE should flash so what i deduce is that U CHANGE pa n PHONE went dead after that, IN this case and with THAT ERROR on ufs this sequence try 1:change UEM 2:change upp reason SIMPLE "to much heat apply to BOARD MAYBE" goodluck

11-09-2004, 20:00	#3 (permalink)
gsm_style Freak Poster Join Date: Mar 2003 Location: nederland Age: 52 Posts: 251 Member: 24929 Status: Offline Thanks Meter: 7	thank you man, problem are the pa, change it to an other one and now its ok, thank you for your help

11-09-2004, 21:08	#4 (permalink)
mohammed No Life Poster Join Date: Sep 2002 Location: max232 chip Posts: 690 Member: 16036 Status: Offline Thanks Meter: 5	hi man glad to help