8310 contact service
 

I have griffin so i could put it on normal mode.But with batery always Contact service.What could it be??Testing with griffin show me this

Passed - ST_UPP_REGISTER_VER_TEST
Passed - ST_UEM_CBUS_IF_TEST
Passed - ST_SLEEP_X_LOOP_TEST
Passed - ST_AUX_DA_LOOP_TEST
Passed - ST_EAR_DATA_LOOP_TEST
Passed - ST_TX_IDP_LOOP_TEST
Passed - ST_TX_IQ_DP_LOOP_TEST
Passed - ST_SIM_CLK_LOOP_TEST
Passed - ST_SIM_IO_CTRL_LOOP_TEST
Not executed - ST_IR_LOOP_TEST
Not executed - ST_MBUS_RX_TX_LOOP_TEST
Not executed - ST_BACKUP_BATT_TEST
Not executed - ST_RADIO_TEST
Passed - ST_WARRANTY_TEST
Fail - ST_SIM_LOCK_TEST
Passed - ST_PPM_VALIDITY_TEST
Not executed - ST_KEYBOARD_STUCK_TEST
Not executed - ST_LCD_TEST
Not executed - ST_FLASH_CHECKSUM_TEST
Passed - ST_RF_CHIP_ID_TEST
Passed - ST_IR_IF_TEST
Done

I have rehot UEM and nothing new...Any expert ideea??

Try to rehot power suplly and flash,after that try to flash her again,must work if she have close contact with "wall"....

Unlock the phone with griffin !!!!!!!

WBR
Syed

make this manual test mode:

http://www.gsmhacking.com/help/cables/nokia/dct4_cs.gif

and unlock phone.

regards,

Irinel

Right ! I've test !

this solution is very dangerous!!!!!!!!!!
Pls flashing it in manualmode with Griffin and at last phone in testmode, after that do not remove cable pls unlock when phone in testmode 100% OK!!!!!!!!!!!!!!!!!

SORY IM NEWBIE IS THAT SOLUTION IS TO REMOVE CONTACT SERVICE IN DCT4. I WILL ONLY SHORT THE TERMINALS IN THE BATERRY IN TEST MODE?

TNX IN ADVANCE!!!