No network found in manual search after 2 second - GSM-Forum

.::AkhavanGSM::. · 01-30-2003, 17:13

Today i had 4 3310 phones with same problem.
When i select manual network serach after just 2 seconds:"no network found"
3 of them solved by full flash+epp
but one of them seems to not be software error.
Any Idea?

Fang502001 · 01-30-2003, 19:05

Try changing Cobba...or maybe Antena switch......if this dont help...try changing haggar...or maybe just flow board very good...

.::AkhavanGSM::. · 02-06-2003, 09:36

Cobba+Hager are OK!
I think it is a PCB error

mobilemafia · 02-06-2003, 10:41

crystel or antenna switch

.::AkhavanGSM::. · 02-08-2003, 11:55

Crystal and anntena swith was Ok !

Fang502001 · 02-10-2003, 06:02

try to replace cobba...:-)

amir-cairo · 02-20-2003, 03:21

yr broplem must be on anttena swich or a arowend anttena swich
be sure all contain is ok arownd it
u can check a filters too

MobileSoft · 03-03-2003, 23:49

change the PA

01-30-2003, 17:13	#1 (permalink)
.::AkhavanGSM::. No Life Poster Join Date: Jun 2002 Location: Iran Age: 47 Posts: 1,082 Member: 12724 Status: Offline Thanks Meter: 30	No network found in manual search after 2 second Today i had 4 3310 phones with same problem. When i select manual network serach after just 2 seconds:"no network found" 3 of them solved by full flash+epp but one of them seems to not be software error. Any Idea?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
7610 no network found in 4 sec	rajiv007	Nokia Hardware & Hardware Repair	18	01-12-2010 15:54
3120 no network found in 10 second	Rin2	Nokia Hardware & Hardware Repair	0	05-13-2009 16:28
..ll 3220 no operater found on manual searching ll..	HUM	Nokia Hardware & Hardware Repair	13	10-09-2007 17:32
7610 with no network found in 4 sec	rajiv007	WD2 & APE (Symbian Phones)	0	12-28-2005 15:33
help..... no network found in T105......	RAHUL12345	Sony Ericsson Hardware Repair	2	05-09-2004 13:04

01-30-2003, 19:05	#2 (permalink)
Fang502001 Freak Poster Join Date: Dec 2002 Posts: 148 Member: 19003 Status: Offline Thanks Meter: 0	Try changing Cobba...or maybe Antena switch......if this dont help...try changing haggar...or maybe just flow board very good...

02-06-2003, 09:36	#3 (permalink)
.::AkhavanGSM::. No Life Poster Join Date: Jun 2002 Location: Iran Age: 47 Posts: 1,082 Member: 12724 Status: Offline Thanks Meter: 30	Cobba+Hager are OK! I think it is a PCB error

02-06-2003, 10:41	#4 (permalink)
mobilemafia No Life Poster Join Date: Dec 2001 Location: mumbai Age: 54 Posts: 857 Member: 7889 Status: Offline Thanks Meter: 7	crystel or antenna switch

02-08-2003, 11:55	#5 (permalink)
.::AkhavanGSM::. No Life Poster Join Date: Jun 2002 Location: Iran Age: 47 Posts: 1,082 Member: 12724 Status: Offline Thanks Meter: 30	Crystal and anntena swith was Ok !

02-10-2003, 06:02	#6 (permalink)
Fang502001 Freak Poster Join Date: Dec 2002 Posts: 148 Member: 19003 Status: Offline Thanks Meter: 0	try to replace cobba...:-)

02-20-2003, 03:21	#7 (permalink)
amir-cairo Freak Poster Join Date: May 2002 Location: egypt Age: 46 Posts: 238 Member: 11466 Status: Offline Thanks Meter: 0	yr broplem must be on anttena swich or a arowend anttena swich be sure all contain is ok arownd it u can check a filters too

03-03-2003, 23:49	#8 (permalink)
MobileSoft Freak Poster Join Date: Feb 2001 Location: South Africa Posts: 164 Member: 3355 Status: Offline Thanks Meter: 1	change the PA