help unlock v975 using smartmoto
 

i tried to unlock v975(boot 0.5.f.1).using smartmoto.but always give this error'searching for phone ...found motorola phone(v975)getting test interface ...at command error.this error is possible during phone turning on ,you may try <search >once again .
anyone knows how to solve it .thank you

You need to use SmartMoto to unlock these models.
- Power on the phone.
- Connect it to PC via smart-clip, detect your phone in SmartMoto.
- Go to Unlock bookmark, pick your model, press "Start unlock procedure" button.
- Phone goes into boot mode, reserve copy of security area is created.
- Part of phone Firmware is reflashed.
- Phone doesn't power on after that. SmartMoto will give you the message requiring to take phone into boot mode using keys combination: *,#, PWR ON (at this moment the phone has to be connected by usb cable) or using Rapper cable.
Press "OK" button. Wait till the process ends.
The phone powers on and is ready to be unlocked by Smart-Clip using simple "press one button" method (press Unlock button on Smart-Clip).

it depends on what firmware the phone has. Smartmoto and Smartclip cannot unlock v975 with boot 0.5.F.1 sw R245_U_82_31_56I and at this moment neither can MSS4 :(

no my brother i unlock it by smart clip

wrok by smart clip 10%%%%%%%%

are you sure? v975 with this boot loader and this software? I spent 2 days trying with SmartMoto and SmartClip, Also trying with Victor MSS4 versions 4.0.0.8 and 4.0.0.9 beta and it wasnt until today that victor says no solution yet but they working on it. So I very Much doubt that you did it with smart clip :rolleyes:

can you guys just make sure if you v975 boot loader is '0.5.f.1 sw R245-U-82.31.56I',because i need to know that ,i have two with this version.thank you

oh no marklee:-)
 

work 100 percent i have just finished one but many times give me some connection error but i'connected bad the original usb cable
if you need more help write me in pvt or [email protected]

Well the one I tried was exactly the same as this. Tried with smartmoto which gave the message "this can now bw unlocked with smartclip" but each time I tried the green light went to red (error). I dont think these people can distinguish between the sw versions because I know some versions are supported the same as mss4 BUT not this one..........Yet :(

Maybe someone from Smart Team would like to comment on this, taking in mind Model and SW versions :)

This phone needs to be unlocked in normal way (P2K platform), no SmartMoto required.


BR
Smart-clip team
www.smart-clip.com
www.GsmServer.com
www.boot-loader.com
www.smart-unlocker.com

Are you confirming that smatclip does unlock v975 boot loader vr 0.5.f.1 sw R245-U-82.31.56I ?

I personally get the red light when I press unlock and have to disconnect clip from power to reset it (after waiting long time and disconnecting phone.

for me works and understand what's mean v975 boot loader vr 0.5.f.1 sw R245-U-82.31.56I..... h3g phones
Bye Bye

Thanks for that. And you dont have any problems with unlocking this? just connect to clip and press unlock?

Still no confirmation from Smart team that the smatclip actually does unlock v975 boot loader vr 0.5.f.1 sw R245-U-82.31.56I
;) :D ;)