W595 - K850 : What Happens When Change CPU And Flash IC?? - GSM-Forum

ms.4011 · 11-11-2009, 13:13

W595 restart problem ....

tested all soluations for this problem ..

software - customiz - flash with w595a - w595s ..

changed lcd and lcd board - reballed cpu and flash ic ...same problem .

now i changed cpu and flash ic from another w595

but when read hnfo with se tool cannt countinu reading informations

i think there correlation between cpu & flash ic with power ic و
That I did not wrong

any solution for this ...???

thequestions · 11-13-2009, 05:10

cos if u change cpu and flash...u have to write back GDFS again ...if nt ...ur set cant finish full flash 1 ....mst match

kwaku85 · 11-24-2009, 12:09

Nothing like that. You can change Power IC without any problems, so probably You just kill new flash chip/CPU, or nomething goes wrong when You solder new set.

11-11-2009, 13:13	#1 (permalink)
ms.4011 Insane Poster Join Date: Oct 2007 Posts: 82 Member: 615044 Status: Offline Thanks Meter: 7	W595 - K850 : What Happens When Change CPU And Flash IC?? W595 restart problem .... tested all soluations for this problem .. software - customiz - flash with w595a - w595s .. changed lcd and lcd board - reballed cpu and flash ic ...same problem . now i changed cpu and flash ic from another w595 but when read hnfo with se tool cannt countinu reading informations i think there correlation between cpu & flash ic with power ic و That I did not wrong any solution for this ...???

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
n82 hang on nokia logo after change cpu and flash ic	hamid123	Nokia Hardware & Hardware Repair	5	12-24-2009 19:34
V360 - change processor and flash IC.how repair?	Invader	Smart-Clip	3	04-12-2007 15:26
Change MAD and Flash IC!!!!	Mehvishal	Nokia Hardware & Hardware Repair	10	03-21-2005 21:31
What happens if you try and flash past eeprom end address?	Nick-A	Nokia Legacy Phones ( DCT-1 ,2 ,3 ,L )	6	01-14-2002 06:31

11-13-2009, 05:10	#2 (permalink)
thequestions Freak Poster Join Date: Feb 2008 Location: secret Posts: 118 Member: 711270 Status: Offline Thanks Meter: 30	cos if u change cpu and flash...u have to write back GDFS again ...if nt ...ur set cant finish full flash 1 ....mst match

11-24-2009, 12:09	#3 (permalink)
kwaku85 No Life Poster Join Date: Jan 2006 Location: Poland Age: 39 Posts: 630 Member: 219917 Status: Offline Thanks Meter: 60	Nothing like that. You can change Power IC without any problems, so probably You just kill new flash chip/CPU, or nomething goes wrong when You solder new set.