I can not unlock Motorola V3 New Boot Loader and V3i Boot Loader:0A.30 with S_card!!
 

Peace be with you (Greeting to all)
I have problem when i try unlock V3i without Test Point with S_card and Smart Clip when press Prepare phone give me error ( Erasing flash memory error 80)and I see at the screen of phone error(Critical Error)

Detail Of V3i
Boot Loader: 0A.30
SW Version : R479_G_08.B5.3DR

SmartMoto log :

SmartMoto 2.16
S-Card: 00000000 Smart-Clip dongle, v 1.12, assigned Smart-Clip: 000000000Europe, initializing... OK
Clip serial: 000000000, version: 3.12, initializing... OK
Searching for phone... found Motorola Phone (V3i), getting test interface... OK
Model V3i
Firmware R479_G_08.B5.3DR
Switching to flash mode... OK [S Flash Neptune LTE2]
Reading phone boot version... A.30
Sending boot... OK
Performing backup to temporary file
Stored temporary backup to E:\Program Files\GsmServer\SmartMoto\temporary backup\bkp_F929880381992CBB.bk_
Backup OK
Erasing flash memory error 80
Searching for phone... no phone found
Searching for phone... no phone found
Searching for phone... no phone found
Searching for phone... found Motorola Phone (V3i), getting test interface... clip communication failed
Searching for phone... clip communication failed
I have Motorola V3 Boot Loader :08.29 sw Ver :R374_G_0E.42.15R i do not found unlock it with out test point.
Can i unlock it as 0X828 at the program?

__________________________________________________ ____________

Final i hope i can use S_Card with USB Cable for use SmartMoto Program(Unlock and flash) and without Smart Clip

Thanks.
Best Regards.
[glow=yellow]GsmOrient[/glow]

@ GsmOrient,

Please run Prepare cycle exactly as written in manual.
Log file should be like this one:
About Clip Communiacation error: In case of getting an error "Clip communication failed", while detecting the handset, please check the output of Smart-Clip power source. For stable Smart-Clip functions minimum output is 9V & 500mA. Recommended power supply is 12V & 750mA.

Some phone models use a data cable for charging. So, as soon as it gets connected to Smart-Clip it starts charging and uses about 500mA, plus Clip requires another 130-150mA.

V3 with boot 8.29 can be done via TP.

Best Regards
Smart-clip team
www.smart-clip.com
www.GsmServer.com
www.boot-loader.com
www.smart-unlocker.com

Thanks for reply
Now my phone unlocked ok with S_card and Smart Clip after more tries but i need know what is the meaning of (Erasing flash memory error 80) in program and critical error 40 20 at the scrren of phone
I hope that i can unlock Motorola V3 Boot Loader :08.29 with out Test Point with the next update.
Thanks.
Best Regards.
[glow=yellow]GsmOrient[/glow]