j100 unlock with smart clip doesnt work
 

Hi

I have 2 j100 both can´t be unlocked with smart clip I have bought j100 cable but when I connect phone to clip on diplay comes charging and nothink happens on smartclip (no blinking led´s) and then green led turns to red. when I press power on phone only turnes on

I also tried this cable with DMtools and jaf com emulator but I think jaf have other RJ45 pinouts so my cable doesn´t work

what am I doing wrong?

greetings

surfer2go

Does the cable that you are using have the same pinout as on the picture?


http://www.smart-clip.com/j100.png



Best Regards
GSMServer team


http://www.gsmserver.com/img/sc_userbar.png

hi

I have bought this cabel

Its factory made so Im afraid I can not oben the RJ45 adapter for ceck this pinout

but the pinout in connector is correct

try with fighter cable or uc10. uc10 works for me:)

This is definitely an issue of the cable or possible the hardware problem of your phone.


Best Regards
GSMServer team


http://www.gsmserver.com/img/sc_userbar.png

I have unlocked around 15 handsets ........No Problem . Do check your cable

How did you unlock the J00i with smart-clip Which modell did you choose, on smrtmoto i can choose only

J110i
J120i
T250/T250i
Z250/Z250i
Z320/Z320i


Thanks.

no mate, U can unlock J100 with CLIP only, no need Smart-Moto.

SmartMoto not required for J100 unlock.
Purchase or build the CORRECT cable.
Connect to the front panel RJ45 port and use the top unlock button.

http://www.smart-clip.com/support.php#acer


;smokin

no bro.......select com and use interface.......

ethier setool or cruiser as use as interface......

unlock button is not run fpr that phone......

SE J100/C115/C116/C117/C118/C139/C140/C155/C156/E365/V170/V171 unlocking procedure
1. Power off the phone.
2. Connect the Clip to the phone using RJ45 cable (see pinout schematic below).
3. Press UNLOCK button.
4. Press Power button on the phone within 5 seconds after you press UNLOCK button on the Clip. RX/TX leds will blink.
5. E/G led will glow green on success.*

* After successful unlock (green led on) phones with inserted sim card may ask for PCK or NCK code. Enter 00000000 ("zero" 8 times).

I have a little Problem, i hope somebody can help me,

i have a Sony Ericsson J100i, i would like to unlock it with the Smart-clip.

I have the J100 Cable this one:

http://www.handy-style.de/index/cat163/2633

The problem is, If i connect the J100i RJ45 cable to the Smart-clip, the Smart-Clip switches off, If i connect other Cable to the smart-clip
everything is OK, Only with the J100i Cable. Maybe, its the wrong cable?


Thanks

@ powerplay83,

More likely that the cable you have is faulty.


http://www.gsmserver.com/img/sc_userbar.png
Best Regards
Smart-clip team
www.smart-clip.com
www.scoutdongle.com
www.GsmServer.com
www.boot-loader.com
www.smart-unlocker.com

Please give me schematic for this cable
Thanck you!