smart-clip Team Look here !!!!!!!!!!!!
 

this is result after C975 test point ,phone always in flash mode this is not a problem , problem is :
Clip serial: **********, version: 2.18, initializing... OK
Searching for phone... found S Flash Rainbow POG, getting test interface... interface not found
Switching to flash mode... OK
Reading phone boot version... 5.F1
Reading bus width... OK
Reading flash id... Micron-MT28F1284W18BET (x2)
Phone group: C975,C980,V980
Hardware IMEI: 354991000686768
Security area saved to "S Flash Rainbow POG 354991000686768 .pds"
Writing section1 D4800/1FE0000... 2% 80.4 Kb/sec sector erase error
Extended sector erase error code is A00080

i can`t flash this phone always error
Old boot was 6.36
i flash 5.F1 boot and Make Rsa all is done but can`t flash
whats opinions !!!!!!!!!!!!!

very good work smart team
Minosgsm

Please make sure phone's battery is fully charged..


Best Regards
Smart-clip team
www.smart-clip.com
www.GsmServer.com
www.boot-loader.com
www.smart-unlocker.com

Totally Agree Just Got Same problem battery was Gone...Fully Charge Battery probelm Solved..And do i need to Do repair PDS again for full Flashing SC Team plz reply and do i need to check Overwrite bootArea as well While flashing after PDS repair???

i thinks when you use smart-clip,don't use battery,please use adapter 9v,i use adapter and not have problem...

i work in this phone with salam
battery is full charge and i am always use adaptor with 9 volt phone still give this error !!!!!
i use power supply and i get the same ....... !!!!!!!!!!

smart-clip team it is 4 days on this phone can u help ?

I have a similar problem. I tried flashing the phone to downgrade boot (using TP of course) it never worked, I got this error from the beginning. In my case phone's bootloader is detected as 3.10
Tried flashing with fullflash with overwrite boot area selected but SC says something about the phone eing A835 and so on then internal error 0001.
Tried flashing only boot file from support and I get the same error as SALLAM, that is:
Extended sector erase error code is A00080
PLEASE, PLEASE, give us the solution for this. Thank you very very much!

was trying to unlock moto c975 with smart clip, after putting the test point phone
was found, after writing the boot file phone not geting on and displaying a massage
boot loader
0.5.f.1
sw version:
r24_u_80.2f.36.01p
battery ok
ok to program
transfer mode:
serial rs-232
and when i flash with the full flash file it gives an error after 1%
extended sector erase error code is a00080,
plz help me out urgent

Tried anything and everything that's been posted regarding this subject and nothing is working. I'm 100% certain this is not HW problem so if anyone, SC Team in particular, has a viable, working solution to this problem please don't hesitate to share.
I don't know how big of a problem this is for others, but in my case I had to replace the customer's phone and this cost me a month's paycheck. So it's either starve to death or fix it. Smart-Clip support doesn't seem to care too much about my problems and won't answer me in ICQ. Maybe they'll look here... maybe.... just maybe :(
Thanks