v3t unlocking problem ?
 

i have v3t which i try to unlock prepare phone .. its version is a.30..

SmartMoto 3.22
S-Card: ******* Smart-Clip dongle, v 2.12, assigned Smart-Clip: ******** Europe, initializing... OK
Clip serial: ***********, version: 4.09, initializing... OK
Searching for phone... found Motorola Phone (V3t), getting test interface... OK
Model V3t
Firmware R3443U5_G_0E.C8.0DR
Switching to flash mode... reconnect error
Switching to flash mode... could not get USB descriptor
Searching for phone... found Motorola Phone (V3t), getting test interface... OK
Model V3t
Firmware R3443U5_G_0E.C8.0DR
Switching to flash mode... OK [S Flash Neptune LTE2]
Reading phone boot version... A.30
Sending boot... OK
Performing backup to temporary file
Stored temporary backup to C:\Program Files\GsmServer\SmartMoto\temporary backup\bkp_F9019E13028978B4.bk_
Backup OK
Erasing flash memory error 80
Searching for phone... found Motorola Phone (V3t), getting test interface... OK
Switching to flash mode... OK [S Flash Neptune LTE2]
Reading phone boot version... A.30
Sending boot... OK
Erasing flash memory OK
Sending firmware OK
Searching for phone... found S Blank Neptune LTE2
Switching to flash mode... OK
Reading phone boot version... 3.00
Reading flash id... Intel - 28F256L18B
Reading flash id/2... Intel - 28F128L18T, OK
Phone group: V235,V360,V360v,V3i,V3r,L7,L7e,L7v,L71,L72,L9,K1,U 3,W5,W490,W510,Z3
Hardware IMEI: 353286010443842
IMEI OTP status: locked
Security area saved to "PDS for S Blank Neptune LTE2 353286010443842.mbk"
Performing restore from temparary backup file C:\Program Files\GsmServer\SmartMoto\temporary backup\bkp_F9019E13028978B4.bk_
WARNING: Restore operation failed. Try to perform 'prepare phone' operation or flash the phone with full flash file again
Preparing... "Prepare phone" operation failed
io timeout

i got this error in v3r also... can any one tell where is the error ?

testpoint and unlock again,post result

its not tp phone .. no need to do unlock with test point...

What model did you pick from the list in SmartMoto and what exactly steps did you perform?
Also, was the phone's battery fully charged and what power supply did you use with Smart-Clip?



Best Regards
GSMServer team


http://www.gsmserver.com/img/sc_userbar_1.png