Nec N8
 

i have a nec8 and i don't have charger so i bought a data cable and now i whant to build a charger.... but i don't have pinouts .... could anyone help me telling witch pins i use for charging .... and volts


thank u very much!!!

i really need this guys!!!

please guys help me ..... all you heve to do is open your charger and look to what pins are the cables connected!!! same charger works on nec e606! please i really need this pinout!!!

i have one charger but it is not charging .... it looks like this...


() ||||||||||

from left to right:

1 and 10 gnd, 6 + ........ but i am sure that is wrong!!! at the battery pins i get only 1,5 V

see if you have 5v-max 6v and over 0.5A at the charging connector!!!!

I allready made one chatger for that

charger has over 5v but at battery i have 1 v!!

do not have over 6v because it enter in protection mode.
if the battery level it is very low it inly blinks(the red led from the up of the phone) a while and then it start to charge........

please tito2002 don't play with me please tell me on wich pins should i put + and - ...... please give me your mail or icq to talk

@tito2002

i have the connector wich looks like this: () ||||||||||
i have the power supply wich generates 5,6 v and 0.8 mAh
i have cable

what i do not know is where (on the connector), on witch pin (there are 10) should i put + (from power supply) and where - (ground)...... that is where i need the real help!!


for exemple if the connector looks like this:

(0) | | | | | | | | | |
1............11

on pin 3 you should have + and on 1 u should have - (gnd)



thank u very much for helping me!!!!


:D:D:D:D:D

I I I I I I I I I I O
1 10

1 - Gnd
2- Gnd
5- Vcc

When i made cable i had an original charger to mesure. At the original charger i had 5,35 v (in sarcina) and 5.65v (in gol), but that is not so important you can use 5v to 6.5v....

You can mail me at: [email protected] or call me at 0722408363