c139 new pcb & and old tp kill the phone

[rogerboogie]

hi dear infinity some days ago i try to unlock one c139 ver 9.2.17

where tp needed its remove ball n1 from cpu , i unlock serveral pieces of this model with n1 procedure but this time i have a problem

the pcb its diferent

i try to unlock removing the n1 pin from pcb like all other and after this phone is totaly dead

also have new flash ic iside

here is the model

MemoCom
K1032004BT-GB1
0801-KS
ECB76799700

I DONT KNOW IF CPU ITS DIFERENT I THOUGT SO

HERE IS THE LETTERS IN CPU

0751749ZHH
7CAR9TW $4

please help to research about this new revision of pcb to have unlock

thanks in advance

br

roger

[rogerboogie]

dont have any info about it ?

[YellowBoss]

Hi,
Is it was any errors during unlock process ?

[rogerboogie]

no , at all the phone became dead after remove the solder point of pcb of n1 ball

its not the first time i have just unlocked this phone by removing n1 solder point of pcb i always remove this track , but this time the pcb are completely diferent and the old n1 point posision its not the same i think cpu is diferent in this type of pcb`s

and... just and idea

the leds of infinity box blink rx & tx as the old c139 , in my experience the old tp phones by cuting track when i try to read with infinity box , the box boot the phone as usual, i can see rx & tx leds blinking but

in boot erased phones when i try to read the phone just one led is blinking.

in the case of this phone i think is not boot erased because when i try to read with inifity box i can see the 2 led blinking just like the old rev of pcb with non boot ereased

sorry if my explanation its not good because really i dont know nothing about programming but i see this diferences betwen

thanks for response

br

roger