GSM-Forum - Can't calibrate touch screen on Alfatel H1

GSM-Forum (https://forum.gsmhosting.com/vbb/)

- Infinity-Box (https://forum.gsmhosting.com/vbb/f296/)

- - Can't calibrate touch screen on Alfatel H1 (https://forum.gsmhosting.com/vbb/f296/cant-calibrate-touch-screen-alfatel-h1-757630/)

Can't calibrate touch screen on Alfatel H1

Hello to all,

I have one phone H1 in my hand phone is working fine. But i can't calibrate the touch screen:mad: Here is the Log of calibration.

Code:

COM5 [VCP1] selected

module  v2.82

Action: touchscreen calibration

mode: 1

Model: Autodetect 6205-6227 NOR

Checking data, wait...

Phone should be Switched OFF !

Press and HOLD Power button now !

19200 autodetect

Initializing [6225:8A03:8A00]...

CPU: MT6225

high speed boot On

chip: 0001:3503:000D

status: FF

Connecting at 19200, wait...

Release Power button now !

Phone detected, wait...

warning: can't read software version, probably unknown firmware

detecting structure #2...

 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18warning: wrong packet cs

 19 20 21 22 23 24 25 26 27warning: wrong packet cs

 28 29error: detection failed (30 tries), read flash and send to support

connection lost

error: operation failed !

Finished, time used: 10 sec

Remove/Install battery now !

Also i try with Reverse calibration too but same error show :eek:
Anyone know how to solve this problem !!!!!:D

Thankx in advance.

hello!

what do you use as interface?

I use Infinity as Interface.
Spider Couldn't find this set pin out.
That's why i open the set & use Rx-Tx-Gnd point for connect the phone.

hello!

make format FFS comlete
power on phone, wait 30 sec
power off phone
repeat calibration again
please note that you must try all calibration methods
if will not work- post here all logs, we will check them all and if needed i will request full flash for processing