Qmobile i6 metal 2018 Flashed Successfully Cm2sp 2.2
 

Operation : Flash Firmware [ v2.02 ]

Setting : Update NVRAM : False
Setting : Force NVRAM : False
Setting : Update PMT : True

1. Power off device, wait 10-15 seconds
2. Press and hold BooKey ( 1 : BOTH VOL , 2 : VOL+ , 3 : VOL- )
3. Insert cable in device!

Wait for device ...

Device Connected!
BootVersion : SPRD3
Boot : PAC : QMobile_i6 Metal 2018_MP_V5.0_01_08.pac
Sending Init Boot ...
Boot sent!
Kick FDL ...
BootVersion : Spreadtrum Boot Block version 1.1
Protocol setup ...
Port speed : 921600
Sending Flash Boot ...
Boot sent!
Kick FLASH FDL ...
FDL : Control transfered!

Boot Done!

PMTMng : Load PMT
PMTMng : 0x20
PMTMng : Update PMT Ok!

CODE : prodnv.img
ERASE : UBOOT
UBOOT : u-boot-spl-16k-sign.bin
CODE : SC9600_pike2_pubcp_modem.dat
CODE : pike2_pubcp_deltanv.bin
CODE : PIKE2_DM_DSP.bin
CODE : pike2_cm4.bin
CODE : PM_pike2_cm4.bin
CODE : boot.img
CODE : recovery.img
FSIMG : system.img
FSIMG : userdata.img
CODE : boot_logo.bmp
CODE : fastboot_logo.bmp
FSIMG : cache.img
FSIMG : vendor.img
ERASE : W_RUNTIMENV1
ERASE : MISC
CODE : tos-sign.bin
CODE : sml-sign.bin
UBOOT : u-boot-sign.bin
FSIMG : persist.img
CODE : gnssbdmodem.bin
CODE : gnssmodem.bin
CODE : vbmeta-sign.img

Flashing finished!

Reconnect Power/Cable!


Done!
Elapsed: 00:05:39

Can You Please Share Firmware ?????

yes i will share you in few hours

Not Working plz help

Please Share Firmware Link