HW/SW Fault detection for dct4 phone.

[Mohsin-*]

we will see on this thread how is it helpfull to post always OK_log and how to read it to detect hw fault or sw fault for DCT4 phone incleading (WD2, tuki).

example of DCT4 phone: 1100 - 1110i - 6600 - 6230 ... .

important:
1st of all to be sure about result need to get good cable. 10 pin (recommended).

2nd to avoid damage your box never connect dead phone directly to your box, need first to check batterie connector (+,-) using multimetre to test if there is any short.

this is our first log from a working phone to be our reference:

 
============= Set Flash mode for info ============= VBat is 3.94V >> with intact box you must get value entre 3.0 ~ 4.07 V Vpp pin has 1.30V, ConnectedPins: Mbus 1, Box Tx 1, Box Rx 1, Bsi 0Boot...DCT4u_2nd.fia -->> upp is OKu_st_i.fia -->> flash loader 
ASIC ID: 2201


Configuration Info (9F):Number of Flashes: 2 
01000000: SGS, 0020 8823 0000 0121, 10 >> ic flash is detected02000000: NotUsed, 0000 0001 0000 0000, 0ExtBUSC: AD7E B61A 1BBE 0BE2 7D58 6BE4 DBEE 6514 >> bus Adress OKUEM IMEI is: 35793000072700 >> UEM_chip/imei_serial is OK.============= Set FBus mode for info =============VBat is 3.94VVpp pin has 1.31V, ConnectedPins:Mbus 1, Box Tx 1, Box Rx 1, Bsi 0Phone is in: Local modeModel: RH-18 ( 1100a) ----------------------\V 8.11/19-06-06/RH-18 (c) NMP/1100 --------> phone soft is OKIMEI: 357930000727005 ---------------------/

with good cable and working phone we must get this log.