cannot remove CELL PH0NE ic - GSM-Forum

mobileworld9 · 05-12-2010, 16:31

the given below procedure is practically checked by me as per the instructions from the jovy system manual.
first of all we start the mechine and wait five minutes for before starting the procedure.and then put the board on the mechine. andalso put the thermo coupler nearer to the IC. next we start the lower heater in reflow mode.
in reflow mode the lower heater time taken upto 15 minutes for reaching 80degree temp, and in fast reflow mode it was taken 9minutes.
next we start the upper heater(the mechine in level 3). it was taken 20minutes(including L.H.time) for reaching 140degree temp but IC was cannot removed.then it was go to sleep mode
until we connected the USB mode for using contol rom software. we select the lead free profile and run this it was reaches 210degree temp but the time taken was upto 20minutes. in this profile the graph shown in three stages to reach this temprture but the IC cannot removed and the board was damaged.
we set the mechine in sleep mode in 20 minutes.
we are tried this procedure for model no 6600 uem IC.

Raheeeeb · 05-16-2010, 09:29

Did you try to use your right and contacted the Support by e-mail or by skype ?!!!!

Regards

Raheeeeb

05-12-2010, 16:31	#1 (permalink)
mobileworld9 Major Poster Join Date: Nov 2006 Posts: 46 Member: 392243 Status: Offline Thanks Meter: 6	cannot remove CELL PH0NE ic the given below procedure is practically checked by me as per the instructions from the jovy system manual. first of all we start the mechine and wait five minutes for before starting the procedure.and then put the board on the mechine. andalso put the thermo coupler nearer to the IC. next we start the lower heater in reflow mode. in reflow mode the lower heater time taken upto 15 minutes for reaching 80degree temp, and in fast reflow mode it was taken 9minutes. next we start the upper heater(the mechine in level 3). it was taken 20minutes(including L.H.time) for reaching 140degree temp but IC was cannot removed.then it was go to sleep mode until we connected the USB mode for using contol rom software. we select the lead free profile and run this it was reaches 210degree temp but the time taken was upto 20minutes. in this profile the graph shown in three stages to reach this temprture but the IC cannot removed and the board was damaged. we set the mechine in sleep mode in 20 minutes. we are tried this procedure for model no 6600 uem IC.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
sp lock 1,2,3,4 removed	spterminator	Nokia Legacy Phones ( DCT-1 ,2 ,3 ,L )	10	08-09-2010 10:20
Problems removing the GID lock with new SIM's	MrProdent	Nokia Legacy Phones ( DCT-1 ,2 ,3 ,L )	10	02-17-2004 00:00
How do I remove a network provider lock?	james.bond007	Nokia Legacy Phones ( DCT-1 ,2 ,3 ,L )	3	03-02-2000 22:59
£20 only NOKIA 51xx/61xx sp locks 1,2,3,4 removed	spterminator	Main Sales Section	0	08-08-1999 05:08

05-16-2010, 09:29	#2 (permalink)
Raheeeeb No Life Poster Join Date: Oct 2001 Location: -------- Age: 55 Posts: 1,009 Member: 7062 Status: Offline Thanks Meter: 126	Did you try to use your right and contacted the Support by e-mail or by skype ?!!!! Regards Raheeeeb