hi team in mtk cannot detect pinouts in infinion always detect wrong pinouts
 

hi team when i select mtk cannot detect pinouts in infinion detect always wrong pinouts .....here is log when i search in mtk


[ 20:39:41 ] [--- Operation Started ---]
[ 20:39:41 ] Detecting power pins...
[ 20:39:44 ] Detected GND : 14,17
[ 20:39:44 ] Detected VCC : 24
[ 20:39:45 ] Searching for pinout...
[ 20:39:45 ] Pinout does not detected!
[ 20:39:45 ] Change Speed and try again!
[ 20:39:45 ] [--- Operation Finished! ---


here is log when i select infinion
and detect pinouts

[ 20:51:10 ] [--- Operation Started ---]
[ 20:51:10 ] Detecting power pins...
[ 20:51:13 ] Detected GND : 14,17,19
[ 20:51:13 ] Detected VCC : 24
[ 20:51:13 ] Searching for pinout...
[ 20:52:36 ] Pinout detected OK!
[ 20:52:36 ] RX : 1 TX : 5
[ 20:52:36 ] Writing settings to Box...
[ 20:52:38 ] Settings has been written OK!
[ 20:52:38 ] [--- Operation Successful! ---


and here is log when i detect with easy fnd pinot way

[ 20:59:26 ] [--- Phone should be ON! ---]
[ 20:59:28 ] Detected GND : 14,17
[ 20:59:28 ] Searching for pinout...
[ 21:02:02 ] Pinout detected OK!
[ 21:02:02 ] RX : 23 TX : 12
[ 21:02:03 ] Writing settings to Box...
[ 21:02:05 ] Settings has been written OK!
[ 21:02:05 ] [--- Operation Successful!




[!



where i am wrong plz help me i hold the power button whole the time and infinion is always wrong i think


wbr

varun

When you have MTK, you must select MTK only.
Change speed to FAST and search again.

HÝ
MC TEAM WHEN Ý SELECK MTK ONLY AND Ý SELECK PÝN OUT FROM CABLO STÝCKER
BUT ALL MESSAGE GÝVEÝNG MC TOOL BOX ( Pinout does not detected ) WHAT ÝS PROPLEM
PLEASE CAN YOU GÝVE ANY ÝNFORMATÝON.
[--- Operation Started ---]
Detecting power pins...
Detected GND : 3
Detected VCC :8
Searching for pinout...
Pinout does not detected!
Change Speed and try again!
--- Operation Finished! ---
all is this message
best regards

I Am Also Getting Same Problem

i m also facing the same problem. difference is only u r getting wrong pinouts in infenion ......& i m getting this in spreadtrum..

where is the support team plz give us a answer....asap

Remove + and - crodocile again plug
click auto find pinout after HOLD power on key DONT remove hand.... wait for finish