6280 not unlock read my PROBLEM
 

i try to UNLOCK 6280 with new setup 1.98.48 & 1.98.49 but all time eror Tp is
100000000 % ok...

LOCK STATUS:

CONFIG KEY: 8000000000000006
PROVIDER KEY: 5050600042465540
Provider: Hutchinson 3G;Australia
Key Code count: 3, FBUS Code count: 0

Block 1:
Lock 1: CLOSED -> Lock Data: 50506F
Block 2:
Lock 1: CLOSED -> Lock Data: 50599F
Block 3:
Lock 1: CLOSED -> Lock Data: 00101F

Reading phone...Type: RM-78, Ver: 06.43
Reading imei...
Imei: 357926005412833
Reading HW ID...2003
Found general data...
Waiting for TP confirmation...............................Sending code...
Error unlocking! Code: FFFFFFFF

i can not use the old s/w of jaf 1.98.45 or 1.98.47 after update my P-KEY in new version .. jaf s/w can not open in old exe. and in new s/w always give error .. any one tested new exe in any BB5 phone ?

thanx in addv. ;)

Try to replace your ini file again as link below . I tried unlock 6280 / 6233 yesterday in new version v49 without any problem .

http://forum./show...8&postcount=11

all try but always different error :mad:

Did you tick TP unlock at Unlock Setting Tab ? Or try disconnect GND and do it again . Hopeful could help you out .

see this http:///vbb/showth...=466971&page=2 , this is not my first mobile:mad::mad::mad::mad: any way thanks for help...

i think time to be change .........

hihi . Update your P-key again and also if Firmware Update are available on v49 just press it . Then copy and paste V-spac ini.file update to jaf directory and test unlock again . I unlocked many phones but never miss up with V-spac ;) Mayb im lucky :eek:

ok now !!!
 

unlock ok now !!!:mad::mad::mad: