Iphone 4, logo 1 sec then off Hello all I was testing a new screen for my iPhone 4, and after reinserting the battery the screen flashed with Apple logo for 1 sec and then the phone turned off. It is dead untill I remove battery and then it does the same. Without battery and into the computer port, the screen does the same. I put the motherboard into another iPhone, but the problem is the same, so I guess the problem is with the board/software. I can put the phone into DFU mode and iTunes finds it but without serial and screen only show a logo shortly and then turns off. When trying to restore I get an error 21. Please help. |
change your battery and try |
Quote:
|
I was searching to help you solve your problem is that error21 is a hardware problem due for a non well fixing connectores or a dust that need to be cleaned and from a bad assembly I think you need to dissamble your phone again and try to assembled correctly that what's appeared with me by searching to solve your problem Please try and post result |
I already put the entire mainboard into another Iphone, and it acted excactly the same in that case... it could of course be a connection gone bad. |
Many problems caused for error 21 please read from this linkhttps://www.ifixit.com/Answers/View/...tting+Error+21 |
it's battery connector missing tracks. check and make jumpers. for battery connector ways ip4 search google. |
Quote:
http://gsmresolutionworld.********.d...s-problem.html All has perfectly fine connections and no shorts. |
change your battery.. (battery replacement) |
|
When an iPhone turns on for a second and turns back off, it means it's not detecting the battery. Try to replace your battery. It can be from a damaged battery cable. If that doesn't work, then battery connector needs to be replaced and soldered. Last and least common, IC needs replacement.. Hope i helped. |
Thanks for the suggestion, I have tried with two different batteries. No go. Wouldn't the phone turn on when no battery is inserted but connected to power? When measuring on the red points what should my multimeter be set to measure? Resistance? What is buzzer mode on the drawing? |
If the iPhone is functioning normally, it should turn on the apple screen then off without a battery and connected to pc or charger. |
Without the battery and connected to a charger the same thing happens with the fast <1 sec Apple logo flash. |
Does it keep restarting? or just flashes once? |
I can put it into DFU mode with the battery disconnected, itunes finds the phone in DFU no serial no, but ITunes wont complete restore, error 21. redsn0w detects the phone in DFU mode, and after using the tool for leaving recovery loop, it says restarting, but then I just see apple logo flash quickly, and this repeats itself every 15 sec. And it gets warm just around the flash memory area. |
Did you solder new connectors on the motherboard for the battery? That can be the issue. Try to use a charged battery and turn on the phone without being plugged in charger see if the apple screen shows up. |
I managed to put the phone into pwn DFU, and thereafter it actually completed a restore, it programmed firmware and baseband. All went well, but after completion it flashed apple logo and black screen. However it actually booted, played a tune and got activated with Itunes which now recognizes it show serialno and pnone number. Screen is black, but it responds to cable out and in, and in itunes I can see the batery is charged at 63%. So I guess it is the screen connector afterall, I have tried with another lcd but the same problem. |
All times are GMT +1. The time now is 10:42. |
vBulletin Optimisation provided by
vB Optimise (Pro) -
vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.
- GSM Hosting Ltd. - 1999-2023 -