vepro canot find pinoouts sigmatel s 1 s 2 s3
 

hi all vepro can not find pinouts sigmatel s 1 s2 s3 i tried many phones but no sucess plz tell where i am wrong ........or i canot use vepro with infinity ............always error using latest




wbr
varun

what is the cpu of the phones ? and what error it shows ?
you may do as the manual shows

cpu is mt 6225 and i canot use vepro with infinity when i format with infinity it says read error ............wbr varun

you can use vepro II box or supper star box to pinfind .

www.hengwei168.com

yes this is a big problem with vepro box...i hv to open mobile to attach rx tx then format with infinity.

where is support..no one is answering....vepro finding pinouts 4 sigmatel yet giving initial error while formating.also infinity cant format on these pinouts..may be cant find actual pinouts.....supporter plz solve that problem.

ve-pro detects sigmatel s3........
use cable xtl8a xtl12b
pinouts

2-Vcc
5-Txd
7-Gnd
8-Rxd
11-Gnd

yes it detects by this cable but can not format phone by infinity or vipro .plz product supporter try to solve problem

yes this is what i want to say.."it detects by this cable but can not format phone by infinity or vipro".

What is mobile condition ?
If Mobile is dead then heat on flash IC. Then format mobile.


G:):)d luck.

no support in this section from ve...plz reply supporter...if there is no rx tx define on charging jeck how we format the set...????
mostly we r facing problem in sigmtel's set..becouse vepro defines incorrect rx tx in these sets...

If shows initial error while format, maybe, it is not the correct pin out, so, you have to choose the “Repeat Scan” and scan again.

yes it is clear that it is not finding correct pinouts as pinouts finding by pinfinder is different from that.....i hv tried all thing like including repeat scan as in video course..if anyoe hv successfully format s3 with vepro plz give screenshots..thx..

i format so many sigmatel models successfully. first set spytime to 500ms if , rx.tx not detected then try in spytime 1000ms, both attempts in normal mode.remember first try in spytime 500ms then 1000ms .post me result, one more important was hold power button untilll finish format if not succes use battery for format after spy success