T39
 

Program hang when trying to flash ARM
Just say sending ARM software byt nothing happens.

AVR flash working fine but no sucsess with ARM.
Cruiser 3.70

http://www.gsmforum.se/cruiser.jpg

BR
Nizze

Hello,

Have you tried with Cruiser 3.82?

Sven

why is the checkbox ''relock RSA'' ticked ? ;)

I think the_microe found your problem... ;)

That was not the problem. He was using my cable (since I was modifying his cable with adding PS/2 for LG cable) and I had done the "enhanced cable" modification to my cable and when he cut those resistors it all worked just fine again.

And no, I haven't done a bad job on that mod either... But still everything works better with no mod.

//Niclas

T39 does not have any RSA certificated area, so why even relock it ?

It might have worked better if you had set Cruiser to know that enhanced cables had been connected...

Just the same, my cable is unmodified anyway ;)

Because it was like that when I conected to phone, and it was not posible to untick it.

@Evan_Silbert

Nope, that doesn't work for me. I have tried to tick that box but nothing happens. I can not tick that I am using the enhanced cable, all done according to the schematics shown here in the forum earlier.

//Niclas

try to select T39 model via the combo-box manually or try lower baudrate speed - or maybe try to rehot flash ic.

have you downloaded the flashes from here ?http://www.microengineers.cc/cruiser...m_T39mc/R4A008

w8.
nobody "borrows" t39/r520 SCRC algo until now.
only one TEAM has it.
IT IS NOT OUR.

ASK other teams.

w8.
nobody "borrows" t39/r520 SCRC algo until now.
only one TEAM has it.
IT IS NOT OUR.

ASK other teams.

I read post at GTI that Cruiser will release solution for T39/T65/R520. Is it true?

If ARM not flashing ... try reflow the ARM Chip
 

@ NIZZ

Try reflowing the ARM chip , it may help.


GL