ST21i2 problem resurrect

[Velko]

Try change TCK speed but not result .

this is log:


Connecting to the dead body...OK
Detected dead body ID: 0x106040E1 - CORRECT!
Set I/O Voltage reads as 2.61V, TCK Frequency is RTCK
Adaptive Clocking RTCK Sampling is: [Sample at 2 MHz]

Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK

WARNING: DCC Loader was unable to initialize FLASH1 chip. Error code: 0x00000048

ERROR: Selected FLASH Chip was not initialized by the DCC Loader.

[Faheem Anjum]

its Emmc problem .........

[BABAK NURI]

RIFF JTAG Box FAQ - WARNING: DCC Loader was unable to initialize FLASH1 chip.
Reheat or Replace eMMC Then Repair TA(after replace)

[debeliamark]

Originally Posted by Velko

Try change TCK speed but not result .

this is log:


Connecting to the dead body...OK
Detected dead body ID: 0x106040E1 - CORRECT!
Set I/O Voltage reads as 2.61V, TCK Frequency is RTCK
Adaptive Clocking RTCK Sampling is: [Sample at 2 MHz]

Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK

WARNING: DCC Loader was unable to initialize FLASH1 chip. Error code: 0x00000048

ERROR: Selected FLASH Chip was not initialized by the DCC Loader.

Dear Velko - this crappy xPeria Dual have most common problem for latest cheap phones - damaged eMMC, but ... you cannot reborn it, due to no way to rebuild security units with RIFF ... i was made such experiment - to place new empty eMMC - well - it's boot rewrited, but ... this is useless. May be Medusa can help in situation, but i haven't.