| harim_1981 | 07-15-2014 08:59 |
SE st21i2 after resurrect also not detected..
hi
ST21i2 resurrection completed fine. Quote:
[7/15/2014 11:34:17 AM] [START OPERATION_ID = RESURRECT]
[7/15/2014 11:36:22 AM] Open serial port...OK
[7/15/2014 11:36:22 AM] Connecting to the RIFF Box...OK
[7/15/2014 11:36:22 AM] Firmware Version: 1.37, JTAG Manager Version: 1.56
[7/15/2014 11:36:22 AM] Selected Resurrector: [SE ST21i2 V1.0.5194.44713]
[7/15/2014 11:36:22 AM]
[7/15/2014 11:36:22 AM] Connecting to the dead body...OK
[7/15/2014 11:36:22 AM] Detected dead body ID: 0x106040E1 - CORRECT!
[7/15/2014 11:36:22 AM] Set I/O Voltage reads as 2.60V, TCK Frequency is RTCK
[7/15/2014 11:36:22 AM] Adaptive Clocking RTCK Sampling is: [Sample at MAX]
[7/15/2014 11:36:22 AM]
[7/15/2014 11:36:22 AM] Resurrection sequence started.
[7/15/2014 11:36:22 AM] Establish communication with the phone...OK
[7/15/2014 11:36:22 AM] Initializing internal hardware configuration...OK
[7/15/2014 11:36:22 AM] Uploading resurrector data into memory...OK
[7/15/2014 11:36:22 AM] Starting communication with resurrector...OK
[7/15/2014 11:36:22 AM]
[7/15/2014 11:36:22 AM] Detected an Initialized FLASH1 Chip, ID: 0x0015/0x0100 (SJS00M, 0x0000E9000000 Bytes = 3.64 GB)
[7/15/2014 11:36:22 AM] Detected an Initialized FLASH2 Chip, ID: 0x0015/0x0100 (SJS00M, 0x000000100000 Bytes = 1.00 MB)
[7/15/2014 11:36:22 AM]
[7/15/2014 11:36:22 AM] Flashing the dead body...OK
[7/15/2014 11:36:22 AM] Resurrection complete!
[7/15/2014 11:36:22 AM] [FINISH OPERATION_ID = RESURRECT]
| but after this also not detected by USB
also only red light blinking
need full dump ?
thanks | 