N73 rm-133 not fully conected.how i remove its user code
 

UFS S/N 126534 boot - Ok

Connect phone on selected interface...

Init Service Mode Failed, can't proceed checking... :(

Connect phone on selected interface...

Read and Check phone data...
BB5 bus checking...
Setting FlashMode
FlashMode set Ok

1st boot Ok, C0

APE part info :
APE ASICID : 17100708
APE MODE ID : 00
APE PUB ID : C3003DF5F9E123B77437BB687D7276283DF89897
APE R_HASH : 49A97E826B93BA20B7ED0B082475C005
APE ROM ID : 1DFD66132C872FD4

CMT part info :
CMT ASICID : 000000010000022600010006010C192101003000
CMT EM0 ID : 00000295
CMT EM1 ID : 00000B22
CMT PUB ID : 05A0000ADFAE4F5040F6027ABAA0C7B647E23780
CMT MODE ID : 00
CMT R_HASH : BAF3A9C3DBFA8454937DB77F2B8852B1
CMT ROM ID : 273F6D55DFAAF68F

[1ST BOOT] : Boot Ok , A6
CMT : Sending 2nd loader...
Use : RAP3Gv3_2nd.fg , Rev : 0.0 Ver : 10.42.0
CMT Loader sent, Boot Ok
MCU Configuration
MCU Cfg Ok , 03
FLASHID : 22E800EC , CMT , NOR
CMT Flash ID : 22E800EC < SAMSUNG [SEC] => K5G2829ATC
FLCNT : 00000000000000000000000000000000000000
FLASHID : 0000FFFF , CMT , MMC , EXT
CMT Flash ID : 0000FFFF < Bad Flash Type , if MMC - It Ok
[2ND BOOT] : CMT : Boot Ok
Sending ALGO....
Use : RAP3Gv3_algo.fg , Rev : 0.0 Ver : 10.40.0
CMT Algo sent
CMT PAPUB : 5E8D0D504A0902E261268C14FCD8A2C9093523BCBD
[ALGO BOOT] : CMT : Boot Ok
Transmission mode : Dual (Ddr, TX2)

APE : Sending 2nd loader...
Use : helen3_2nd.fg , Rev : 0.0 Ver : 1.35.0
APE Loader sent, Boot Ok
MCU Configuration
MCU Cfg Ok , 02
FLASHID : 00A100EC , APE ,
APE Flash ID : 00A100EC < SAMSUNG [SEC] => K5E1G12ACM [NAND]
FLCNT : 010100FFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFF
[2ND BOOT] : APE : Boot Ok
Sending ALGO....
Use : h3_sam_nand_xsr.fg , Rev : 0.0 Ver : 1.47.0
APE Algo sent
APE PAPUB : 5E8D0D504A0902E261268C14FCD8A2C9093523BCBC
Transmission mode : Dual (Ddr, TX2)
[ALGO BOOT] : APE : Boot Ok
[BOOT] : Ok , target ready
PrReq : NOR , 00
PrReq : NAND , 01030000504A0900E261260014FCD8

Init Service mode... Wait...