TA-1034 Device is not supported yet!

[sajer007]

Operation : Reset Settings [ v1.20 ]

1. Make sure device is powered off. Power off, if need. Wait 10 seconds after
2. Insert USB cable in phone
Waiting for device connection ...

PTFN : Care Suite USB Serial Port (COM64)
MODE : NOKIA USB SERIAL
PORT : 64
BROM : Init BROM
BROM init passed!
CHIP : MT6261 , SBID : 0xCB01 , HWVR : 0x8000 , SWVR : 0x0001
BROM : SECCFG : 0x00000000
BROM : NOKIA USB SERIAL

Info : Device is not supported yet!

Reconnect Power/Cable!

[ahmer5050]

Hi Sir.
Plz Check Drivers Or Pc.
This Device Already Supported.
Check This One.
Open VPLfile : TA-1034_059Z107_30.04.11.vpl
Description : TA-1034 IJ
DeviceType : TA-1034
ProductCode : 059Z107
SoftwareVer : 30.04.11
PPM LangPack :
[1] : Urdu (Islamic Republic of Pakistan)
[2] : English (United Kingdom)
Load Ok!

Operation : Write FirmWare [ v1.20 ]
Setting : UserData erase : True
Setting : LangPack Only : True

1. Make sure device is powered off. Power off, if need. Wait 10 seconds after
2. Insert USB cable in phone
Waiting for device connection ...

PTFN : Nokia USB Serial Port (COM25)
MODE : NOKIA USB SERIAL
PORT : 25
BROM : Init BROM
BROM init passed!
CHIP : MT6261 , SBID : 0xCB01 , HWVR : 0x8000 , SWVR : 0x0001
BROM : SECCFG : 0x00000007
BROM : NOKIA USB SERIAL
BROM : 0x05 BL : 0x00
BROM : MEID : 6BBEB98CEF6620BF90F6C37C9DA03FE8
BROM : Run BootLoader ...
BOOT : Run BL ver. 01
BOOT : 0x05 BL : 0x01
BOOT : WD : 0005
BOOT : RTC : Setup ...
BOOT : RTC : 000E
BOOT : PRJ : N103.30.04.11.p1
BOOT : SWR : 30.04.11
AGENT : Look for suitable BootChain in DA ...
AGENT : DEFAULT AUTO
AGENT : Found MT6261
AGENT : N103.30.04.11.p1
BOOT : Sending 1st DA ...
BOOT : DA sent
BOOT : Transfer control to DA ...
DA : Sync Passed!
DA : Authentification pass!
DA : Agent : v03.02 on BBID : 0x8E

NOR: 00C8 : 0060 : 0016 : 0000
NOR: [GigaDevice] GD25LQ32
NOR:
TSIZE : 0x00400000 [ 4.00 MB ]
PSIZE : 0x00400000 [ 4.00 MB ]
STYPE : 0x00000000
FLOTP : DA_NOR_OTP_EXIST

STATUS : OK
BSTYLE : SF_FLASH_BOOT

Boot done!

VPL SoftwareVersion : 30.04.11 [TA-1034]
DEV SoftwareVersion : 30.04.11
SWInfo compare result : SAME

Load FlashSet :
LANG : TA-1034_LANG_PACK_ROM_IJ_eMP_30.04.11_001
CUST : TA-1034_CUSTPACK_ROM_IJ_eMP_30.04.11_001
JUMP : TA-1034_JUMP_TABLE_IJ_eMP_30.04.11_001

Prepare FlashSet :
DCR : TA-1034_LANG_PACK_ROM_IJ_eMP_30.04.11_001
DCR : TA-1034_CUSTPACK_ROM_IJ_eMP_30.04.11_001
DCR : TA-1034_JUMP_TABLE_IJ_eMP_30.04.11_001

Prepare Target
SDS : OK : 0x003F8000 : 0x00008000
FFS Format Ok!

Erase Target Flash
Erase done!

Write Target Flash
Write : TA-1034_LANG_PACK_ROM_IJ_eMP_30.04.11_001
Write : TA-1034_CUSTPACK_ROM_IJ_eMP_30.04.11_001
Write : TA-1034_JUMP_TABLE_IJ_eMP_30.04.11_001
Write done, waiting target response ...
Write flash done!

Verify Target FlashContent
Verify : TA-1034_LANG_PACK_ROM_IJ_eMP_30.04.11_001
Verify : TA-1034_CUSTPACK_ROM_IJ_eMP_30.04.11_001
Verify : TA-1034_JUMP_TABLE_IJ_eMP_30.04.11_001

Done!
Elapsed: 00:00:45

[profkefah]

probably u have fake nokia

check on CM2MTK if u can read info

[sajer007]

i thinkdriver problem mobile no fake

[profkefah]

bro
if driver no detection

but it say
Info : Device is not supported yet!

market flooded with clone 105 130 etc

[Brka]

Originally Posted by sajer007

i thinkdriver problem mobile no fake

Check my post please ...

https://forum.gsmhosting.com/vbb/f64.../#post14244027

Does this device looks like Clone/fake ? Well, it doesn't,
but it's fake/clone ta-1034, and trust me - phone menu,
icons, display, all looks like 100% original, but phone is detected
as "MTK USB Port xx" (not CareSuite USB port).

I was shocked at first, also ...

b.r.
Alex