|
|
 |
|
Welcome to the GSM-Forum forums. You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. Only registered members may post questions, contact other members or search our database of over 8 million posts. Registration is fast, simple and absolutely free so please - Click to REGISTER! If you have any problems with the registration process or your account login, please contact contact us . |
| |||||||
| Register | FAQ | Donate | Forum Rules | Root any Device | ★iPhone Unlock★ | ★ Direct Codes ★ | Direct Unlock Source |
| Easy-Jtag / Easy-Jtag Plus The official support section. You can ask here your question and get answer regarding using Easy-Jtag / Easy-Jtag Plus. |
 |
| | LinkBack | Thread Tools | Display Modes |
09-08-2020, 22:14
| #1 (permalink) |
| Freak Poster  Join Date: Jan 2010 Location: india
Posts: 321
Member: 1213513 Status: Offline Sonork: jhone Thanks Meter: 23 |  dear team i try repai emmc read write ok 1.remove permanent write protect 2.recommend update emmc firmware ( if failed just unplug usb adapter and update again) 3.movinad factory reset and erase 4.write dump 5.enjoy buy some to drink, flash your phone 6.repair imei/write cert Report Post i write dump EMMC_ROM1_MAG2GA_3817359279_00000000_20000000 EMMC_ROM2_MAG2GA_3817359279_00000000_00200000 Loading eMMC GEN1 Firmware... IO: 2800 mV Box S/N: 0100502280652FAE, ,FW Ver.: 01.63 Warning: CMD Pullup Level (0 mV) too low , check cables etc.! CMD Active Level:938 mV Box IO Level:2800 mV CLK Rate:21000 kHz Bus Width:1bit,SDR HiPower mode is off! Can't init device, Reason: CMD Timeout Error Done. now emmc note detect can team provide me direct emmc tp for this emmc plz thanks |
 |
|
| Bookmarks |
| |
|
|
Linear Mode
