GSM-Forum
Page 1 of 2 1 2
Show 50 post(s) from this thread on one page

GSM-Forum (https://forum.gsmhosting.com/vbb/)
-   Easy-Jtag / Easy-Jtag Plus (https://forum.gsmhosting.com/vbb/f672/)
-   -   G531F CMD timeout error (https://forum.gsmhosting.com/vbb/f672/g531f-cmd-timeout-error-2306113/)

usernome 12-15-2017 16:11
G531F CMD timeout error
 
Code:
Compression is ON
Z3X EasyJtag Software ver. 2.6.0.1
Loading eMMC GEN1 Firmware... IO: 2800 mV
Box S/N: xxxxxxxxxxxx, ,FW Ver.: 01.60
CMD Pullup Level:1732 mV
CMD Active Level:2155 mV
Box IO Level:2800 mV
CLK Rate:14000 khz
HiPower mode is off!
Can't init device, Reason: CMD Timeout Error
Done.
1,8V and 2,8V disconnected , powered by USB cable .

usernome 12-16-2017 23:13
Can anyone help me ?

laxmi kamlesh 12-17-2017 14:12
Quote:
Originally Posted by usernome (Post 12847254)
Can anyone help me ?
Connection Issue Or Emmc Dead

usernome 12-18-2017 13:43
It can't be dead . The phone was working .
The phone died after a downgrade .

laxmi kamlesh 12-18-2017 15:02
check clk resistance

usernome 12-18-2017 21:26
Quote:
Originally Posted by laxmi kamlesh (Post 12849821)
check clk resistance
The wire goes directly under the chip , why should I check the resistance ?

usernome 12-19-2017 17:30
So , is there any solution ?

buntydk1 12-19-2017 18:58
G531f
 
Same problem is my g531f esayjtag not connected and error
And atf same adapter connected ok

usernome 12-20-2017 14:38
Is there anybody here ?
You must understand that we cannot keep our customers forever .
Thanks !

shahjee 12-20-2017 19:07
Try to Use pull-up resistor method


Sent from my iPhone using Tapatalk

usernome 12-21-2017 12:58
Quote:
Originally Posted by shahjee (Post 12854669)
Try to Use pull-up resistor method


Sent from my iPhone using Tapatalk
I did that of course ...

usernome 12-22-2017 18:40
So , is there any solution ?

usernome 12-27-2017 13:44
Is there anybody here ?

usernome 01-09-2018 19:20
So , is there any solution ?

shahjee 01-09-2018 20:52
Change cmd resistor or try to connect other side of resistor


Sent from my iPhone using Tapatalk


All times are GMT +1. The time now is 22:46.
Page 1 of 2 1 2
Show 50 post(s) from this thread on one page


vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.
- GSM Hosting Ltd. - 1999-2023 -

Page generated in 0.13594 seconds with 6 queries

SEO by vBSEO