|
|
 |
|
Welcome to the GSM-Forum forums. You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. Only registered members may post questions, contact other members or search our database of over 8 million posts. Registration is fast, simple and absolutely free so please - Click to REGISTER! If you have any problems with the registration process or your account login, please contact contact us . |
| |||||||
| Register | FAQ | Donate | Forum Rules | Root any Device | ★iPhone Unlock★ | ★ Direct Codes ★ | Direct Unlock Source |
| Easy-Jtag / Easy-Jtag Plus The official support section. You can ask here your question and get answer regarding using Easy-Jtag / Easy-Jtag Plus. |
 |
| | LinkBack | Thread Tools | Display Modes |
02-19-2021, 12:56
| #1 (permalink) |
| Freak Poster  Join Date: Mar 2009 Location: morocco Age: 38
Posts: 224
Member: 986038 Status: Offline Thanks Meter: 43 |  jtag plus V2 error read emmc Found 3 serial devices COM87 FTDIBUS\COMPORT&VID_0403&PID_0011 USB Serial Port (COM87) COM1 ACPI\VEN_PNP&DEV_0501 Communications Port (COM1) COM36 USB\VID_0325&PID_0032&REV_0100&MI_00 Easy Jtag Plus Control Port (COM36) Selected pinout: EasyJTAG GEN1 ISP Pinout Change EasyJTAG Pinout OK Z3X EasyJtag Software ver. 3.7.0.20 Loading eMMC GEN1 Firmware... IO: 2800 mV Box S/N: xxxxxxxxxxxxxxx, ,FW Ver.: 01.63 Warning: CMD Pullup Level (0 mV) too low , check cables etc.!this read lin eroor CMD Active Level:2310 mV Box IO Level:2800 mV CLK Rate:21000 kHz Bus Width:1bit,SDR HiPower mode is ON! Can't init device, Reason: CMD Timeout Error Done. please anyone can guide me fix this problem |
 |
|
02-22-2021, 14:03
| #2 (permalink) | |
| Product Supporter   Join Date: Jun 2002 Location: Belarus Age: 47
Posts: 3,187
Member: 13148 Status: Offline Thanks Meter: 2,948 | Quote:
you message not correct you need check you isp connection | |
| |
|
| Bookmarks |
| |
|
|
Linear Mode
