NEW UPDATE EasyJtag v3.7.0.23 for a team, please fix it

[CoMoBat]

box detected in "shell" and "box_diag"
Comport and smart card are OK
No any dongle and box connected at the same time to PC and just Easy is connected

no problem with erase and write dump

Problem is just when press "detect" in software and show in picture error and closed and when install old version and press "detect", worked correctly

[durgesh4rbl]

and Ufs Chip working fine But when emmc detect tool is crash

[aichi-gsm]

hi team please my box shows me this error without any adapter or phone connected please how fix my box
Found 2 serial devices
COM1 ACPI\VEN_PNP&DEV_0501 Communications Port (COM1)
COM40 USB\VID_0325&PID_0032&REV_0100&MI_00 Easy Jtag Control Port (COM40)
Selected pinout: EasyJTAG GEN1 ISP Pinout
Change EasyJTAG Pinout OK
Z3X EasyJtag Software ver. 3.7.0.23
Loading eMMC GEN1 Firmware... IO: 2800 mV
Box S/N: 080, ,FW Ver.: 01.63
Warning: CMD Pullup Level (0 mV) too low , check cables etc.!
CMD Active Level:2351 mV
Box IO Level:2800 mV
CLK Rate:21000 kHz
Bus Width:1bit,SDR
HiPower mode is ON!
Can't init device, Reason: CMD Timeout Error
Done.

[hardnsoft67]

Post here your cpu details
Use windows 10 if its core i5
If cpu amd then *** will help you

[durgesh4rbl]

[CoMoBat]

@Layder

for me work all options...
Also worked fine for eMMC firmware update

just when press on "detect", SW be crach and closed



Please check programing codes and recampile this version again ...

Thanks