J600F screen lock bypass issue

[psytr0nic]

hi , I tried Remove Pin option but doesent work .
I like know if I do Remove Frp the phone data will remain?
then I could flash a custom recovery to finish process .

Get firmware version

Brand = samsung
Manufacturer = samsung
Device = j6lte
Model = SM-J600F
CPU Abi = armeabi-v7a
Android release = 8.0.0
Firmware version = R16NW.J600FXXU3ASA1
Firmware date = Fri Jan 18 16:18:28 KST 2019

HiPower mode is ON
Setting frequence to 21 MHz
CMD Pullup Level: 381 mV
CMD Active Level: 2289 mV
EMMC Device Information :
EMMC CID: 150100424A54443452008209FC2765EA
EMMC CSD: D02701320F5903FFF6DBFFEF8E40400C
EMMC Manufacture : SAMSUNG , EMMC NAME: BJTD4R , HEX: 424A54443452 , S/N: 8209FC27 , rev. 0x00
EMMC Manufacture ID: 0x15 , OEM ID: 0x00 , Device Type: BGA (Discrete embedded) , Date: 6/2018
EMMC ROM 1 (Main User Data) Capacity: 29820 MB (000747C00000)
EMMC ROM 2/3 (Boot Partition 1/2) Capacity: 4096 KB (000000400000)
EMMC RPMB (Replay Protected Memory Block) Capacity: 16384 KB (000001000000) Counter: 2 , Response: Not Clean
EMMC Permanent Write Protection: No
EMMC Temporary Write Protection: No
Extended CSD Information :
Extended CSD rev: 1.8 (MMC 5.1)
Boot configuration [PARTITION_CONFIG]: 0x48 , Boot from: ROM2 (Boot partition 1)
Boot Bus Config: 0x01 , width 4bit
H/W Reset Function [RST_N_FUNCTION]: 0x00, RST_n signal is temporarily disabled
Supported partition features [PARTITIONING_SUPPORT]: 0x07
Device supports partitioning features
Device can have enhanced technological features in partitions and user data area
Device can have extended partitions attribute
Partition Settings [PARTITION_SETTING_COMPLETED]: 0x00
Backup saved: BJTD4R_8209FC27_20191224_000214.extcsd
EMMC Init completed.

Operation: Remove Android Locks

Mount [efs] successfully PartType: LINUX
Mount [cpefs] successfully PartType: LINUX
Mount [PERSISTENT] SKIPPED PartType: FRP <<< FRP !!!
Mount [SYSTEM] successfully PartType: LINUX
Mount [VENDOR] successfully PartType: LINUX
Mount [ODM] successfully PartType: LINUX
Mount [cache] successfully PartType: LINUX
Mount [HIDDEN] successfully PartType: LINUX
Mount [omr] successfully PartType: LINUX
Mount [USERDATA] SKIPPED PartType: Full Disk Encryption

Files not found

[layder]

Originally Posted by psytr0nic

hi , I tried Remove Pin option but doesent work .
I like know if I do Remove Frp the phone data will remain?
then I could flash a custom recovery to finish process .

Function for remove Pin and Gesture key work only at non-eccrypted data partition

[psytr0nic]

Originally Posted by layder

Function for remove Pin and Gesture key work only at non-eccrypted data partition

i like to know if doing frp couldnt erase data