Oppo A92 Reason: UTP: Failed to NOP request - GSM-Forum

newfoundghori · 05-14-2021, 11:24

hi,, oppo a92 ufs error,,

soldered wire is good.,but i get this error..

Quote:

Identify UFS Chip.
UFS Chip Voltage: Low
Can't init device, Code: -113, Reason: UTP: Failed to NOP request
VCC: 3343mV
VCCQ2: 1929mV

Done.

Quote:

Identify UFS Chip.
UFS Chip Voltage: Low
Can't init device, Code: -112, Reason: Can't boot device
VCC: 3343mV
VCCQ2: 1932mV

Done.

newfoundghori · 05-14-2021, 11:27

Z3X EasyJtag Software ver. 3.7.0.20
UFS Socket Info.
Serial: 012355964BB18AADEE
Description: EasyJTAG UFS Socket BGA-254 by EasyJTAG 09.12.20

Identify UFS Chip.
UFS Chip Voltage: Low
Can't init device, Code: -112, Reason: Can't boot device
VCC: 3343mV
VCCQ2: 1932mV

Done.

newfoundghori · 05-14-2021, 11:42

hi, prombelm solve.....hehehe

Quote:

Health:
Device life time method A: 0x01 (0%-10% device life time used)
Device life time method B: 0x01 (0%-10% device life time used)
Pre End of Life: 0x01 (Used less then 80% of reserved blocks)

Format OPPO MISC on LUN 0.
Writing Recovery Command to MISC (2)
Done.

OK
Done.

karimgsm · 11-30-2021, 09:21

Quote:

Originally Posted by newfoundghori

hi, prombelm solve.....hehehe

I have the same problem with Samsung M215F
at first time all is ok i can read dump and securitry files
i write bootlooad with write vendor tab
but phone note boot
i open phone again and sold wires all is ok but phone can t connect
have this error :
Can't init device, Code: -113, Reason: UTP: Failed to NOP request
can u share solution please

05-14-2021, 11:27	#2 (permalink)
newfoundghori No Life Poster Join Date: Aug 2007 Location: Promise Land, Age: 34 Posts: 1,646 Member: 575597 Status: Offline Sonork: 100.1590575 Thanks Meter: 559	Z3X EasyJtag Software ver. 3.7.0.20 UFS Socket Info. Serial: 012355964BB18AADEE Description: EasyJTAG UFS Socket BGA-254 by EasyJTAG 09.12.20 Identify UFS Chip. UFS Chip Voltage: Low Can't init device, Code: -112, Reason: Can't boot device VCC: 3343mV VCCQ2: 1932mV Done.