S5380D boot repair help! Done with error(s)... - GSM-Forum

kennyt1 · 01-27-2014, 08:13

This is my S5380D Easy Jtag boot repair log shown as below:

Code:

EasyJtag Suite ver.: 1.0.94.0 started.
Operating system ver.: Windows XP (build 2600, Service Pack 3).
Successefuly connected to box on COM11
Box S/N: 0800E0065C47DDBF, ,FW Ver.: 01.48
Box Working Mode: JTAG Box.
Box Drivers version: 3.0.0.0, are OK
Z3X Card Serial : AA6C-03CB , ver: 22 
Loading repair file: 'G:\Phone tool\z3x\easy jtag\s5380d\Samsung GT-S5380D.rcp'
Repair File ver. : Easy Repair for Mfg: SAMSUNG Model: GT-S5380D, Ver.: 1.00
Error loading information!
Easy-Repair file load OK!
Using EasyRepair Mode...
Checking repair data...
EasyJtag Suite ver.: 1.0.94.0 started.
Operating system ver.: Windows XP (build 2600, Service Pack 3).
For support and updates visit http://easy-jtag.com
Initialising: SAMSUNG GT-S5380D Config ver.:1.00
I/O Level set to : 3000 mV
Box S/N: 0800E0065C47DDBF ,FW Ver.: 01.48
Connecting to Target...
Done with error(s)...

all connection to main board was done, please advice is there any step miss out

**blang** · 01-28-2014, 13:11

Quote:

Originally Posted by kennyt1

This is my S5380D Easy Jtag boot repair log shown as below:

Code:

EasyJtag Suite ver.: 1.0.94.0 started.
Operating system ver.: Windows XP (build 2600, Service Pack 3).
Successefuly connected to box on COM11
Box S/N: 0800E0065C47DDBF, ,FW Ver.: 01.48
Box Working Mode: JTAG Box.
Box Drivers version: 3.0.0.0, are OK
Z3X Card Serial : AA6C-03CB , ver: 22 
Loading repair file: 'G:\Phone tool\z3x\easy jtag\s5380d\Samsung GT-S5380D.rcp'
Repair File ver. : Easy Repair for Mfg: SAMSUNG Model: GT-S5380D, Ver.: 1.00
Error loading information!
Easy-Repair file load OK!
Using EasyRepair Mode...
Checking repair data...
EasyJtag Suite ver.: 1.0.94.0 started.
Operating system ver.: Windows XP (build 2600, Service Pack 3).
For support and updates visit http://easy-jtag.com
Initialising: SAMSUNG GT-S5380D Config ver.:1.00
I/O Level set to : 3000 mV
Box S/N: 0800E0065C47DDBF ,FW Ver.: 01.48
Connecting to Target...
Done with error(s)...

all connection to main board was done, please advice is there any step miss out

if you sure - everything right from your side, - then problem in hardware

Artyr · 05-31-2014, 08:39

pinout in rcp incorrect,see pinout ort or riff

05-31-2014, 08:39	#3 (permalink)
Artyr Insane Poster Join Date: Dec 2012 Posts: 79 Member: 1859138 Status: Offline Thanks Meter: 20	pinout in rcp incorrect,see pinout ort or riff