SAMSUNG moviNAND KMDV6000DM-BXXX/128G FFU File Need

[CHIEF OF GSM]

SAMSUNG moviNAND KMDV6000DM-BXXX/128G FFU File Need


Any One Share

Selected pinout: GEN2 High Speed Pinout
Change EasyJTAG Pinout OK
Z3X EasyJtag Software ver. 3.7.0.24
Loading eMMC GEN2 Firmware... IO: 2800 mV
Initial pull results:
clock: 1341mV pin connected ok
command: 1739mV pin connected ok
data0: 1724mV pin connected ok
data1: 1738mV pin connected ok
data2: 1737mV pin connected ok
data3: 1740mV pin connected ok
data4: 1739mV pin connected ok
data5: 1739mV pin connected ok
data6: 1737mV pin connected ok
data7: 1740mV pin connected ok
Box S/N: 249329A27FEA4A26, ,FW Ver.: 02.53
Box IO Level:2800 mV
CLK Rate:42000 kHz
Bus Width:8bit,SDR
HiPower mode is off!
---------- eMMC Device Information ----------

eMMC CID : 150100445636444D42023C43C230B571
eMMC CSD : D02701320F5903FFF6DBFFEF8E40400D
eMMC Manufacturer ID: 0015 , OEM ID: 0100
eMMC Date: 11/2018 Rev.0x2
eMMC NAME: DV6DMB , S/N: 1011073584
eMMC NAME (HEX): 445636444D42
EMMC ROM1 (Main User Data) Capacity: 119276 MB
EMMC ROM2 (Boot Partition 1) Capacity: 4096 kB
EMMC ROM3 (Boot Partition 2) Capacity: 4096 kB
EMMC RPMB (Replay Protected Memory Block) Capacity: 16384 kB
EMMC RPMB is not yet programmed (clear) or RPMB General failure
EMMC Permanent Write Protection: No
EMMC Temporary Write Protection: No
EMMC Password Locked: No
Extended CSD rev 1.8 (MMC 5.1)
Boot configuration [PARTITION_CONFIG: 0x48] Boot from:ROM2 (Boot Partition 1)
Boot bus config [177]: 0x02 , width 8bits , Partition config [179]: 0x48.
H/W reset function [RST_N_FUNCTION]: 0x01
High-capacity WP group size [HC_WP_GRP_SIZE: 0x00004000]
Partitioning Support [PARTITIONING_SUPPORT]: 0x07
Device support partitioning feature
Device can have enhanced tech.
Partitioning Setting [PARTITION_SETTING_COMPLETED]: 0x00
---------------------------------------------
Backup saved: DV6DMB_1011073584_20210930_2022.extcsd
Partition info not found
Done.