already posted butt thanks for work hard
http://forum.gsmhosting.com/vbb/f609...tures-1945278/

amazing....:cool::cool::cool::cool:

i know sure i have get much information from your post.

help me on how to connect tp
 

pls sir can u help me with how to connect tp.thanks in advance

pls can u connect magic tp without removing EMMC?:confused::confused:

why cannot repair?
 

Detect Emmc

Z3X EasyJtag Software ver. 2.0.5.0
Loading eMMC Addon Firmware... IO: 3300 mV
Box S/N: 13FFE013D5550B4F, ,FW Ver.: 01.52
CMD Pullup Level:3176 mV
CMD Active Level:3207 mV
eMMC Device Information
EMMC CID : 150100303030303011111111021200B0
EMMC CSD : D02701320F5903FFF6DBFFE796404052
EMMC Manufacturer ID: 0015 , OEM ID: 0100
EMMC Date: 00/2013 Rev.0x11
EMMC NAME: 00000 , S/N: 286327314
EMMC NAME (HEX): 30303030302000
EMMC ROM1 (Main User Data) Capacity: 8192 MB
EMMC ROM2 (Boot Partition 1) Capacity: 1024 kB
EMMC ROM3 (Boot Partition 2) Capacity: 1024 kB
EMMC RPMB (Replay Protected Memory Block) Capacity: 1024 kB
EMMC Permanent Write Protection: No
EMMC Temporary Write Protection: No
Extended CSD rev 1.5 (MMC 4.41)
Boot configuration [PARTITION_CONFIG: 0x00] No boot partition configured.
Boot bus config [177]: 0x00 , width 1bit , Partition config [179]: 0x00.
H/W reset function [RST_N_FUNCTION]: 0x00
Backup saved: 00000 _ 286327314_20151002_1459.extcsd
Done.


Samsung emmc update firmware...

Running:SAMSUNG: eMMC firmware update...
EMMC NAME: 000003
Confirmed eMMC Part Number: KMVTU000LM-B503
Z3X EasyJtag Software ver. 2.0.5.0
Loading eMMC Addon Firmware... IO: 3300 mV
Box S/N: 13FFE013D5550B4F, ,FW Ver.: 01.52
CMD Pullup Level:2103 mV
CMD Active Level:3042 mV
Setup firmware update mode, wait 2..30 sec...
Success!
Sending eMMC firmware...
Success!
Verifying eMMC firmware...
Success!
Flashing eMMC firmware...
Success!
Repairing eMMC CID...
Can't write eMMC CID, Reason: CARD Ready Timeout Error
Done.

nice info and big job.............

SanDisk SDIN5D2-4G
 

Does anyone know the Test Point location on this SanDisk eMMC chip? I am getting the Bad eMMC error message. I want to reset the chip and download the device contents for my customer.
I have an LG 730
Prior to disassembly, the device would not boot. Dead.

will make video in future.......

thanx bro
w8ting for the video

very good work thank you

that not work explain detail

all fak becase how to thoch neduls to tp no gape bord or mmce ic

same problem with i9300

pake post i9300 not warking example no prove