Step by step manual how to repair KMVTU000LM-B503 in pictures. - Page 6 - GSM-Forum

dyracell · 11-06-2017, 13:49

Nice Post i will be save this

dvdxx · 11-09-2017, 11:11

Kingston 08EMCP08-EL3CV100 eMMC Pinout

josh88 · 11-18-2017, 14:04

thank bro keep the good work

usernome · 01-09-2018, 22:47

Code:

Compression is ON
Z3X EasyJtag Software ver. 2.9.0.0
Loading eMMC GEN1 Firmware... IO: 3300 mV
Box S/N: xxxxxxxxxx, ,FW Ver.: 01.62
CMD Pullup Level:3227 mV
CMD Active Level:3248 mV
Box IO Level:3300 mV
CLK Rate:14000 kHz
Bus Width:1bit,SDR
HiPower mode is off!
Can't init device, Reason: CMD Timeout Error 
Done.

What about this error ?

I removed EMMC .

chmsc_ELX · 09-19-2018, 10:21

in direct emmc Moorc is this tp need to do a jumper on the emmc or moorc have built in pinout for tp connection?

Cute_Shibu · 08-03-2021, 16:01

Emmc Now Okay after use Tp Method..

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

11-06-2017, 13:49	#76 (permalink)
dyracell Junior Member Join Date: Sep 2014 Posts: 5 Member: 2264489 Status: Offline Thanks Meter: 2	Nice Post i will be save this

11-09-2017, 11:11	#77 (permalink)
dvdxx Junior Member Join Date: Jan 2011 Posts: 36 Member: 1496327 Status: Offline Thanks Meter: 2	Kingston 08EMCP08-EL3CV100 eMMC Pinout

11-18-2017, 14:04	#78 (permalink)
josh88 Junior Member Join Date: Jul 2017 Posts: 1 Member: 2733118 Status: Offline Thanks Meter: 0	thank bro keep the good work

09-19-2018, 10:21	#80 (permalink)
chmsc_ELX No Life Poster Join Date: Mar 2012 Location: gsm world Posts: 888 Member: 1741973 Status: Offline Thanks Meter: 116	in direct emmc Moorc is this tp need to do a jumper on the emmc or moorc have built in pinout for tp connection?

08-03-2021, 16:01	#81 (permalink)
Cute_Shibu No Life Poster Join Date: Apr 2008 Age: 27 Posts: 1,648 Member: 745672 Status: Offline Sonork: 1640896 : Cute_Shibu Thanks Meter: 551	Emmc Now Okay after use Tp Method..