Zte blade v9 dead after try frp
 

Hi, tried to remove FRP and after fail in the process boot looks dead, how can restore it?


SigmaKey v.2.33.07 build 03
868608259 Sigma dongle 2.33, Initializing...OK
Pack 1: Activated
Pack 2: Activated
Pack 3: Activated
--------- 2019-10-08 19:38:14 ---------
SigmaKey 2.33.07b3 Qcom: Remove FRP / Huawei ID
ZTE Handset Diagnostic Interface (COM116), Provider: ZTE Corporation, Driver ver.: 5.2066.1.9, Date: 02/06/2011, USB\VID_19D2&PID_0500&REV_0318&MI_00
Phone model: Blade V9 Vita
Version: GEN_ZTE_P450F10V1.0.0B31,
Firmware: MPSS.TA.2.3.c11-00056-8953_GEN_PACK-1.145603.1
Date: Mar 6 2019 16:48:49, Apr 13 2018 00:00:00, 8953.gen
Getting info...00000400E1A00900-168D0BAD52B5D5CBB882A90C1DAC68F9299D3905816386BA1B 1887DDA758CF6D
Serial number: 2941635986
Sending boot...Failed

@ mandango,

According to the provided log file, SigmaKey hasn't performed any operations to the phone, just read information from it.
Fully charge phone's battery and Power it on after that.

ZTE Blade V9 phone model is not officially supported by SigmaKey, at the moment.

Best Regards
GSMServer team


http://www.smart-clip.com/img/sigma_userbar.png

At the end turn on again removing battery and reconnect it again.

I suppose was supported because is described in the web looking at "Find a manual for"

@ mandango,

Next time, select "EDL -> Autodetect" in the drop-down list on the right.
Sigma will select the required bootloader automatically, in the Autodetect mode.

Best Regards
GSMServer team


http://www.smart-clip.com/img/sigma_userbar.png

I select EDL>Autodetect then connected power off and nothing happens, don't recognize it, you mean try this way for next time know if is supported or not?

Next time you will know, if Sigma has a bootloader for your phone, or not (with Autodetect feature)