new user help me....
 

Lava 128 jack point miss here two point D+ and D- want to format it mtk625a cpu guide me D+ and D- point work only for mstar or for all......

what kind of help
listen 1st install all phone driver
then use 5130 usb cable

thanks bro........but read post carefully jack point miss........

HELP ME FAST URGENT NEW USERhttp://i57.tinypic.com/11kxf78.png

D+ and D- point work all phone and cpu but want boot key.


br

Lava discover128 no any boot key...i connect other lava128 with data cable(LG3500) with battery it connected no need to press boot key.........

Hello ...



Connect D+,D-,GND point to Universal Jig ..
The Select pin-out Manually like this pic ..

http://s24.postimg.org/7xaokxex1/screenshot_71.png

After Set Pin Out Remove Volcano Main Cable From Box ..
But Still Connect Power Cable or Universal Jig /Cable ..
Follow this Pic bellow ..

http://s24.postimg.org/6jj1pmfnp/screenshot_72.png

• Now Go to MTK Tab ..
• Select Boot 11 ..
• Un-tick Auto Detect Pin-out ..
• Tick USB Mode ..
• Select Read/Write ...
• Do Run ..
• When Software Say Analysis USB ..
• Connect Volcano Main Cable to BOX ..

No Need Any Boot Key that Time ..
Post Result ..




Wbr,
AniAXN

@sumittele

1st you know what is universal JIg ?

If yes then

sold 4 wire board to jig.

1.vcc
2.dm
3.dp
5.gnd

Note : short boot pin to Gnd.

then detect it.and set pinout.

after set pinout .do your work as you want to do.

BR

Don't know about universal jig...here two point save point.... And set point.....if video available then better....also tell what is vcc.....

tell me it right or not.........http://i57.tinypic.com/t688eq.jpg

bro....need vcc for make usb port..

you can take more 1 wire and sold it to vcharg pin( charging+ point)

then try to detect.


BR

tell me it is right or nothttp://i57.tinypic.com/33ati6w.jpg

bro..why you setting pinout manually ?

who said you ?

Follow >>

sold wire like it.

on jig >> on borad
1............vcc /charging pin
2............dp
3.............dm
4.............boot point
5.............gnd

and click on detect pinout. it will detect auto .after that you need to click on set pinout.


BR

sir i pick 1 wire and sold it to vcharg pin( charging+ point) now tell me please in mtk tab use usb mode or auto detect point........

sir solder 1 wire vcc but still not detected..........