Samsung i9300 flashing fail on odin and BST

[EMSE]

A i9300 with hang on samsung logo problem and I try to flash it with single file package with PIT in BST, but it shows the following --

Scanning devices ... 1 found
dev[1]
Manufactory:
Model:
Hardware:
Mode: DOWNLOAD

load pit from files ...
Connect to device ...
Device pit saved to D:\BST\backup\samsung\pit\GT-I9300\GT-I9300_2014-12-11_09.49.35.pit
re-partition ...
get pit data length failed
Finish update process failed

Error happend while updating device
Time used : 20.6 s

And when I try it with Odin3 V3.07 it shows -

<OSM> Enter CS for MD5..
<OSM> Check MD5.. Do not unplug the cable..
<OSM> Please wait..
<OSM> KIES_HOME_I9300ZSEMC1_I9300OZSEMC1_1042642_REV00_u ser_low_ship.tar.md5 is valid.
<OSM> Checking MD5 finished Sucessfully..
<OSM> Leave CS..
<ID:0/030> Added!!
<ID:0/030> Odin v.3 engine (ID:30)..
<ID:0/030> File analysis..
<ID:0/030> SetupConnection..
<ID:0/030> Initialzation..
<ID:0/030> Get PIT for mapping..
<ID:0/030> Firmware update start..
<ID:0/030> boot.img
<ID:0/030> NAND Write Start!!
<ID:0/030> FAIL!
<OSM> All threads completed. (succeed 0 / failed 1)
<OSM> Enter CS for MD5..
<OSM> Check MD5.. Do not unplug the cable..
<OSM> Please wait..
<OSM> I9300XXELL5_I9300VFGELL1_I9300BUELK1_HOME.tar.md5 is valid.
<OSM> Checking MD5 finished Sucessfully..
<OSM> Leave CS..
<ID:0/030> Added!!
<ID:0/030> Odin v.3 engine (ID:30)..
<ID:0/030> File analysis..
<ID:0/030> SetupConnection..
<ID:0/030> Removed!!
<ID:0/030> Initialzation..
<ID:0/030> Get PIT for mapping..
<ID:0/030> Firmware update start..
<ID:0/030> system.img
<ID:0/030> NAND Write Start!!
<ID:0/030> FAIL!
<OSM> All threads completed. (succeed 0 / failed 1)
<ID:0/030> Removed!!

What am I doing wrong ? Please any one help

[Rocks.com.]

Many time posted.......... When NAND Write fail.... its EMMC ISSUE........ REPLACE IT.......