Hot news sony xperia r1 pluse g2299 frp
 

G2299 ANDROID 7.1.2 FRP

USE UMT GSM AND GO TO MISCELLANEOUS
AFTER GO QC FRP RESET

Port : Fastboot Interface
Baud Rate : Not Applicable
Device : Generic
Operation : Qualcomm FRP Reset
Searching for Device in FastBoot Mode... OK
Reading Information... OK
FastBoot Ver. : 0.5
Product : QC_REFERENCE_PHONE
Warranty : Yes
Bootloader : Unlocked
Removing FRP Lock... Done
Operation Finished.
Elapsed Time: 00:02
[Module Ver. 4.8]
Log Saved to Logs\180516_121612.log


USE volume DOWN BUTTON AND CONNECET USB CABLE FOR FastBoot Mode

IF YOU LIKE THEN PRESS THX BUTTON

thx u done sony frp r1

Your explanations is not clear.
WhAt did u use UMT GSM do at 1st?
I can see that FRP as been reset by UMT GSM then what do we need UMT qcfire for again?


PLEASE EXPLAIN WELL.

THANKS IN ADVANCE

thank'you for the news..

if u have UMT box or dongle

open UMT GSM exe.
go to Miscellaneous tab
Tick QC FRP Reset
enter device to fastboot mode.

done sony r1 with umt thanq........sir

thnx afsar bhai thnx i don sony g2299 frp unlock

Operation : Format FS
Checking for existing devices...Found
Port : Qualcomm HS-USB QDLoader 9008 (COM73)
Driver Info : Qualcomm Incorporated, qcusbser.sys, 2.1.2.2
Opening Port...OK
Init Handshake Sequence...OK
Hardware ID : E1F00400 [8937] 00000000
OPK_DATA : 9CBA94693C2333A562BCF0E0E981C558748817D002F543B2A2 6AB1B4B3F1CF9E
Initializing Protocol...OK
Using Auto Loader Selection [3]
Device may possibly not boot with this loader.
Preparing Loader...Done
Sending Loader [8937]...Done
Executing Loader...OK
Detecting Chip Type...OK
Hardware : 8937, eMMC, 16 GB
LU Count : 1 [0x01D1F000]
WARNING! High Speed Driver is not installed.
Please install driver from QcFire\Drivers folder using Device Manager.
Payload Info : In: 65536 [4096], Out: 1048576, Sector Size: 512
Reading Partition Table...OK
Reading Device Information...OK
Device : SONY G2199 [msm8937] [G2199]
Software : S000008_171207, S000008_171207 [2017年 12月 07日 星期四 15:44:31 CST]
Android Ver. : 7.1.2
Patch Level : 2017-12-01
Formatting userdata [SafeMode]...Done
Resetting FRP Lock......Done
Operation Finished.
QcFire Ver. 4.5


done with qc fire