motorola g82 xt2225-1 frp android 13 october 1 2024

[ziko77]

hi,

as in topic,

try evry solution and not work.

is the any soluion for bypas or usb frp unlock
?

thanks for help

br

[Brka]

Originally Posted by ziko77

hi,

as in topic,

try evry solution and not work.

is the any soluion for bypas or usb frp unlock
?

thanks for help

br

First of all ... you need to disassemble device and try to find testpoint.

to do so, check attached picture, and use multimeter (with attached battery),
and measure, first red marked points, to check which is gnd, which is vBat and so on.
next to measure are smaller (green points), to eliminate gnd and vBat, too.

when that is done, use tweezers to connect each (non-vBat) TP to GND
and after connect usb cable (flex from lower board need to be connected for that).

when you get Qualcomm 9008 port (download/flash mode),
write here to give you loader for that model.

p.s. vBat TP's are ones with same voltage as battery (ie: 3.85v, 3.96v, 4.11v etc = 100% vbat tp), DONT connect them to GND/metal shields.

p.s.2 You will need some box/software that can use custom loader as a source. (ie: pandora, unlocktool, etc)

b.r.
Alex

[mesais02]

hi please loader frp moto g82 5g

[Brka]

Originally Posted by mesais02

hi please loader frp moto g82 5g

okay, so where is the WORKING TP for that model ?

read my previous post

b.r.
Alex

[Brka]

small addition ...

looks like factory programmer does not allow access to all partitions (ie: FRP)
on all models ...

this needs to be tested model by model.

b.r.
Alex

[ziko77]

phone bypas not working, unlock tool and uat not supported this phone. finally frp locked and phone sell by client.
its first moto non unlocked by me

[blinet]

loader available, error with every tool, with dft pro it says done but still active
I'm afraid the only way is a cpu drill, or chip off

[FSTEAM]

hi please loader frp moto g82 5g

[Brka]

Originally Posted by blinet

loader available, error with every tool, with dft pro it says done but still active
I'm afraid the only way is a cpu drill, or chip off

it's not about tool, it's about loader limitations.
since it's signed loader ... useless to drill anything.

however ... jtag/isp will do the job.

Originally Posted by FSTEAM

hi please loader frp moto g82 5g

as i said already ... because of loader limitations,
it's useless for anything other than unbrick the device
(it can only write boot partitions / few others essential for phone to start)
the rest of the flashing is done via fastboot.


p.s. It's the same as for all other newer Qcom models.
p.s.2 Even the MTK newer models (ie: G24 Power) have similar design.
BROM requires mandatory SLA auth, so even TP is useless.
(talking about latest sw patches. older android patches dont have closed brom).

Dont play too much with moto phones, you can end buying customer a new phone.


b.r.
Alex