Firmware read done but not flashing with this firmware
 

HAI, ASUS ZENFONE MAX PRO 2 (ASUSX01BDA) IS WITH HANG ON ASUS LOGO. NOT GOING TO RECOVERY OR FASTBOOT MODE. I READ FIRMWARE IN EDL MODE. WHEN I TRIED TO FLASH WITH THIS FIRMWARE, SHOWING FAILED.
https://lh3.googleusercontent.com/1F...-no?authuser=0

We can not see you screenshot. Upload somewhere else and post link again.

Also post log so we can check if any info in available in ErrorLog.

Br,
UMT

Asus zenfone max pro 2 write firmware failed
 

HAI, ASUS ZENFONE MAX PRO 2 (ASUSX01BDA) IS WITH HANG ON ASUS LOGO. I READ FIRMWARE IN EDL MODE. WHEN I TRIED TO FLASH WITH THIS FIRMWARE, SHOWING FAILED.

https://i.postimg.cc/L6dy8mC4/ASUS-ERROR.png



log
Operation : Flash
Checking for existing devices...Found
Port : Qualcomm HS-USB QDLoader 9008 (COM6)
Driver Info : Qualcomm Incorporated, qu_usb_serial.sys, 2.1.2.0
Opening Port...OK
Init Handshake Sequence...OK
Hardware ID : E1C00800 [8996] 00000000
OPK_DATA : 04F8AD2AD41FE15957014A0DC1F60E754590A340DC25378C8F 0674003492FCF4
Initializing Protocol...OK
Using Auto Loader Selection [1]
Preparing Loader...Done
Sending Loader [8996_025]...Done
Executing Loader...OK
Detecting Chip Type...OK
Hardware : MSM8996, eMMC, 64 GB
LU Count : 1 [0x0747C000]
WARNING! High Speed Driver is not installed.
Please install driver from QcFire\Drivers folder using Device Manager.
Payload Info : In: 65536 [4096], Out: 131072, Sector Size: 512
Writing [xbl_0.img] -> [xbl]...Failed
Operation Finished.
QcFire Ver. 5.6

Anyone help me about write firmware