Poco f1 frp done

[lalit bisht]

Operation : Reset FRP
Checking for existing devices...Not Found
Turn Off phone, hold Vol UP + Vol DOWN and insert USB cable.
Some phones may need Special Boot Cable or TestPoint for EDL mode.
Found Port : Qualcomm HS-USB QDLoader 9008 (COM37)
Driver Info : Qualcomm Incorporated, qu_usb_serial.sys, 2.1.2.0
Connecting to phone...OK
Waiting for response...Ignored
Init Handshake Sequence...OK
Hardware ID : E1B00800 [SDM845] 00007200
OPK_DATA : 99AF649E077EBCE3E9E187442ABDC70BD715756DE9ED192E9F 7883A10EBE09F4
Initializing Protocol...OK
Using Auto Loader Selection [1]
Preparing Loader...Done
Sending Loader [SDM845]...Done
Executing Loader...OK
Auth Enabled Device! You may need Mi Auth Account to service!
Skipping Auth...OK
Detecting Storage Type...OK
Hardware : SDM845, UFS, 128 GB
LU Count : 6 [0x01CA5800] [0x00000800] [0x00000800] [0x00002000] [0x00120000] [0x00002000]
WARNING! High Speed Driver is not installed.
Please install driver from QcFire\Drivers folder using Device Manager.
Payload Info : In: 262144 [65536], Out: 16384, Sector Size: 4096
Reading Partition Table...OK
Reading Device Information...OK
Device : Xiaomi
Software : , V12.0.3.0.QEJMIXM [Sun Dec 27 14:13:40 WIB 2020]
Android Ver. : 10
Patch Level : 2020-12-01
Resetting FRP Lock.......Done
Operation Finished.
QcFire Ver. 7.9