Poco f1 frp remove ok
 

HI @LL

LOG IS HERE
---------------------------------------------------------------
Operation : Reset FRP
Checking for existing devices...Found
Port : Qualcomm HS-USB QDLoader 9008 (COM16)
Driver Info : Qualcomm Incorporated, qcusbser.sys, 2.1.2.2
Opening Port...OK
Init Handshake Sequence...OK
Hardware ID : E1B00800 [SDM845] 00007200
OPK_DATA : 99AF649E077EBCE3E9E187442ABDC70BD715756DE9ED192E9F 7883A10EBE09F4
Initializing Protocol...OK
Using Auto Loader Selection [1]
Preparing Loader...Done
Sending Loader [SDM845]...Done
Executing Loader...OK
Auth Enabled Device! You need Mi Auth Account to service!
Reading Auth Blob...OK
Blob : NDE1MTQxNDE0MTQ1NDU0MjQxNDE0NDQ2Nzg2OTUxNDE0NTZBND Y1QTQ5NDY2MTQzNkY0MTJENEY0OTc2NDc1NTcyN0E2MjM0NUY0 MU==
Getting Auth Data...OK
Authenticating...OK
Detecting Chip Type...OK
Using Alternate Method...
Hardware : SDM845, UFS, 128 GB
LU Count : 6 [0x01CA5800] [0x00000800] [0x00000800] [0x00002000] [0x00120000] [0x00002000]
WARNING! High Speed Driver is not installed.
Please install driver from QcFire\Drivers folder using Device Manager.
Payload Info : In: 65536 [65536], Out: 1048576, Sector Size: 4096
Reading Partition Table...OK
Reading Device Information...OK
Device : Xiaomi POCO F1 [beryllium]
Software : PKQ1.180729.001, V10.3.7.0.PEJMIXM [Fri Aug 9 19:16:04 WIB 2019]
Android Ver. : 9
Patch Level : 2019-07-01
Resetting FRP Lock.......Done
Operation Finished.
QcFire Ver. 4.9.1

THANKS UMT