poco m3 i connected phone in edl mode via test point but read info not working
 

Device : Xiaomi Poco M3
Operation : Read Information
Checking for existing devices...Not Found
Turn Off phone, hold Vol UP + Vol DOWN and insert USB cable.
Some phones may need Special Boot Cable or TestPoint for EDL mode.
Found Port : Qualcomm HS-USB QDLoader 9008 (COM5)
Driver Info : Network Connect, qcusbser.sys, 3.0.0.0
Connecting to phone...OK
Waiting for response...OK
Init Handshake Sequence...OK
Hardware ID : E1D01400 [SDM662] 00007200
OPK_DATA : 4B60244704D721E5B96DD5BB7233886E38F2198FBDE6433FCE 1D25A7B0472DD7
Initializing Protocol...OK
Using Auto Loader Selection [1]
Preparing Loader...Done
Sending Loader [SDM662]...Done
Executing Loader...OK
Detecting Chip Type...OK
Hardware : SDM662, UFS, 64 GB
LU Count : 6 [0x00DD4800] [0x00000800] [0x00000800] [0x00008000] [0x00100000] [0x00008000]
WARNING! High Speed Driver is not installed.
Please install driver from QcFire\Drivers folder using Device Manager.
Payload Info : In: 65536 [65536], Out: 16384, Sector Size: 4096
Reading Partition Table...OK
Reading Device Information...Failed
USERDATA : Encrypted
You can use DISABLE LOCKS to Disable Pin/Pattern/Password WITHOUT Data Loss.
Operation Finished.
QcFire Ver. 7.3

what is your phone condition/status?

please post more info about your phone condition/status

b.r.

It may be possible due to super partition structure which holds system, vendor and other products.

We will add parsing of super more properly in upcoming update.

Br,

It may be possible due to super partition structure which holds system, vendor and other products.

We will add parsing of super more properly in upcoming update.

Br,