Read Firmware Huawei G630-u251

[jrbravo]

Device : Huawei G630-U10
Operation : Read Firmware
Checking for existing devices...Found
Port : Qualcomm HS-USB QDLoader 9008 (COM36)
Driver Info : ZTE Corporation, zghsser.sys, 5.2104.1.2
Opening Port...OK
Init Handshake Sequence...OK
Hardware ID : E1408100 [8x26] 00000000
OPK_DATA : 9CBA94693C2333A562BCF0E0E981C558748817D002F543B2A2 6AB1B4B3F1CF9E
Initializing Protocol...OK
Using Auto Loader Selection [1]
Preparing Loader...Done
Sending Loader [8x26_002]...Done
Executing Loader...OK
Detecting Chip Type...OK
Hardware : 8x26, eMMC, 4 GB
LU Count : 1 [0x00748000]
WARNING! High Speed Driver is not installed.
Please install driver from QcFire\Drivers folder using Device Manager.
Payload Info : In: 65536 [4096], Out: 49152, Sector Size: 512
Reading Partition Table...OK
USERDATA : Normal
Reading Device Information...OK
Device : HUAWEI G630-U251 [msm8610] [hwG630-U251]
Software : G630-U251V100R001C00B127, C00B127 [Thu Jul 24 17:59:55 CST 2014]
Android Ver. : 4.3
Reading [sbl1]...Done
Reading [DDR]...Done
Reading [rpm]...Done
Reading [tz]...Done
Reading [aboot]...Done
Reading [modem]...Done
Reading [persist]...Done
Reading [boot]...Done
Reading [recovery]...Done
Reading [cust]...Done
Reading [cache]...Done
Reading [misc]...Done
Reading [system]...Done
Reading [userdata]...Done
Reading [gpt_main0]...Done
Reading [gpt_back0]...Done
Saved to : C:\UMTool\QcFire\Read\HUAWEI_G630-U251_G630-U251V100R001C00B127\
Operation Finished.