vivo X9s enable diag now on logo Device : Vivo X9 Operation : Format FS Checking for existing devices...Not Found Turn Off phone, hold Vol UP + Vol DOWN and insert USB cable. Some phones may need Special Boot Cable or TestPoint for EDL mode. Found Port : Qualcomm HS-USB QDLoader 9008 (COM15) Driver Info : Qualcomm Incorporated, qcusbser.sys, 2.1.2.2 Connecting to phone...OK Waiting for response...Ignored Init Handshake Sequence...OK Hardware ID : E1009900 [8976] 00000000 OPK_DATA : 30315EBED1DD09CEAAE927CAE0EE967076BC178CA33718DB4F FF8F02A0E7FAD2 Initializing Protocol...OK Using Auto Loader Selection [1] Preparing Firehose Loader...Done Sending Loader [8976_003.ufl]...Done Executing Loader...OK Detecting Chip Type...OK Hardware : 8976, eMMC, 64 GB LU Count : 1 [0x0747C000] WARNING! High Speed Driver is not installed. Please install driver from QcFire\Drivers folder using Device Manager. Payload Info : In: 65536 [4096], Out: 1048576, Sector Size: 512 Reading Partition Table...OK Reading Device Information...OK Device : vivo vivo [msm8952] Software : NMF26F release-keys, eng.compil.20180201.204039 [2018年 02月 01日 星期四 20:40:39 CST] Android Ver. : 7.1.1 Patch Level : 2017-12-01 Preparing Data...Done Formatting Userdata...Done Finalizing...Done Operation Finished. Module Ver. 2.0 after doing this still on vivo logo from where to get firmware of this mode ? |
Open log of Enable Diag and read it carefully. Br, UMT |
hello! same problem vivo x9 enable diag now on logo! |
UMT Enabling diag port through qc fire for some device may be stuck in logo, so please Open log of Enable Diag and read it carefully, if device stuck at logo flash it again device will bootup and try to enable diag via code and root method |
All times are GMT +1. The time now is 18:50. |
vBulletin Optimisation provided by
vB Optimise (Pro) -
vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.
- GSM Hosting Ltd. - 1999-2023 -