|
Welcome to the GSM-Forum forums. You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. Only registered members may post questions, contact other members or search our database of over 8 million posts. Registration is fast, simple and absolutely free so please - Click to REGISTER! If you have any problems with the registration process or your account login, please contact contact us . |
|
Register | FAQ | Donate | Forum Rules | Root any Device | ★iPhone Unlock★ | ★ Direct Codes ★ | Direct Unlock Source |
| LinkBack | Thread Tools | Display Modes |
04-27-2017, 08:47 | #1 (permalink) |
No Life Poster Join Date: Jun 2004 Age: 51
Posts: 1,258
Member: 69514 Status: Offline Thanks Meter: 66 | N7100 cannot connect What could be problem? I double checked emmc connections. Welcome to Medusa Pro Software version 1.3.5. Started. Reader #0: FT SCR2000 0 Reader #1: Generic USB Smart Card Reader 0 Please disconnect battery and USB cable. Model Settings: Interface : eMMC Brand : Samsung Model : GT-N7100 SRF : D:/Program Files/Medusa Pro Software/firmwareFolder/SAMSUNG_GT-N7100_EMMC_VTU00M.srf Voltage : 1.8V Bus Mode : 1 Bus speed : Auto Connecting... ERROR[001]: Can not connect. No target device present. Voltage,bus mode & bus speed are set to auto. Should I set them to some particular value? |
04-27-2017, 10:21 | #2 (permalink) | |
Product Supporter Join Date: Mar 2011 Location: Octopus-team
Posts: 9,360
Member: 1538383 Status: Offline Sonork: 100.1587278 Thanks Meter: 3,398 | Hello. Here are a few main possible reasons why the device not connected: 1. You have connected battery or USB cable. Before connecting the device You must disconnect the battery and the USB cable, and then connect the device without power, this is important! 2. Some wires are soldered incorrectly. Carefully check soldering of all wires. 3. In the process of soldering, the resistors were burned (damaged) by using soldering iron or the pin pads on the board to which wires were soldered were damaged. Need replace damaged resistors and restore the pin pads on the board. 4. The ends of wires that were soldered, had not been cleared. Wire, that comes complete with Medusa Pro Box, is covered with an insulator, so before soldering need to clean the ends of each wire. 5. Soldered wires are too long. Make each wire as short as possible (3-5 CM length). 6. For GND connection use more thicker wire. Check all of them and try to connect the device again. Quote:
Also, please look here: http://forum.gsmhosting.com/vbb/f664.../#post12243484, http://forum.gsmhosting.com/vbb/f664...l#post12293055. | |
Bookmarks |
| |
|