i9300 boot repair plase help!
Successfully connected to box on COM91
Box S/N: --------------, ,FW Ver.: 01.48
Loading eMMC Addon Firmware...
Warning: CMD Pullup Level (1082 mV) too low , check cables etc.!!!
CMD Active Level:1041 mV
Warning: CMD Active Level Low !!!
EMMC CID 15010056545530304DF1CC5C4F826FBF
EMMC CSD D02701320F5903FFF6DBFFFF8E40406D
EMMC Manufacturer ID: 0015 , OEM ID: 0100
EMMC Date: 06/2012 FW rev.0xf1
EMMC NAME: VTU00M , S/N: 3428601730
EMMC ROM1 (Main User Data) Capacity: 15028 MB (High Density Card)
EMMC ROM2 (Boot Partition 1) Capacity: 2048 kB
EMMC ROM3 (Boot Partition 2) Capacity: 2048 kB
EMMC RPMB (Replay Protected Memory Block) Capacity: 128 kB
Extended CSD rev 1.6 (MMC 4.5)
Boot configuration [PARTITION_CONFIG: 0x48] Boot from:ROM2 (Boot Partition 1)
Boot bus config [177]: 0x01 , width 4bits , Partition config [179]: 0x48.
Writing 000000200000 bytes to 00000000 ...ROM2
Retry writing adress 0x00000000
Retry writing adress 0x00000000
Retry writing adress 0x00000000
Retry writing adress 0x00000000 |