i followed you instructions, but no success, but i think my soldering is good and wires are thin and short, because when i connect the (flashbus port) i get this:
Manufacturer ID: 0xEF Winbond
Device ID : 0x6017
Flash Capacity : 8388608 Bytes
Flash 64K Blocks: 128 Blocks
Unique ID :
Status Register : 0x00
Resetting ATF Box...
Initializing SPI Module...
Setting VCCIO Voltage...
SPI Module Initialized...
Clocks Sent...
Searching for an SPI Device...
SPI Device Found!
Manufacturer ID: 0xEF Winbond
Device ID : 0x6017
Flash Capacity : 8388608 Bytes
Flash 64K Blocks: 128 Blocks
Unique ID :
Status Register : 0x00
Start Reading 128 Blocks...
Read Blocks Done!
File Saved:
C:\ATF\AdvanceBox Turbo Flasher\SPI\Recovered\tete_FULL.bin
Total Elapsed Time 00:00:09
Resetting ATF Box...
Initializing SPI Module...
Setting VCCIO Voltage...
SPI Module Initialized...
Clocks Sent...
Searching for an SPI Device...
SPI Device Not Found!
Try to Reconnect ATF Box USB Cable
or
Try to Change VCCIO Setting
or
Check your SPI Connections
but is extension port there is no any lifesign. Can i test somehow that my extension port is working right? I think my extension port is not working good.
Many thanx for helping..
ps. i know that it will work only in extension port. |