Dear Gamma cell99 At Bekasi Jakarta you can convert your Nam-1 3610 to Nam-2 2100
Try This:
Used Only Ufs-3/Tornado/Twister/N-Box
Erase Flash Area 0X200000 To 0X600000 Then Re-Flashing With Nam-2 Used Firmware Only Version Nam-2 05.11 With PPm Usually 05.11F, After Flashing MCU+PPM You Will Get Contact Service, Do Rebuilt Imei,Init SIM Lock, Set Faid, Full Factory defaults
It's Old Tricks.... Cause 3610 Have 32MB ic Inside...2100 Have 16MB... Half Capacity destoyed but Half It's OK........ But if still No power on after flash.... you must check the PWB/PCB line....On/Off Goes to Keymath_3_6_9 mostly missing circuit....
Good Luck Mate......
nb. Bekasi Banjir yah........
wassalam
wiradinataR